ZMANALEX

I would check your coolant level from cold and also check the fans are kicking in when sitting stationery. edit: you are to fast for me Will. Alex.

That is correct David. Alex.

to the forum.

PM received and replied to. Crash bars and crash cans are in stock if required. Alex.

One of these, one is toe and the other is camber, I can never remember which is which. 55226 8J000 55226 AL500

Nic, No power gains to be had with these mods without a remap. Informing Privilege about your subtle changes will only complicate the insuring process. Of course if you want to give them the list so that all is transparent and that you have peace of mind, then by all means do so, however I think that it is totally unnecessary. Alex.

to the forum.

to the forum.

It is a balance weight. Alex.

to the forum.

Yes, always wise to give the hydraulic system a prime if the system has run dry. Alex

If the coolant level was good prior to starting your lap of the ring then could be thermostat, head gasket or radiator blockage. Usually the head gasket would blow only after excessive temp was reached, however not always. I am surprised that you did not slow down as the temp started to climb on the gauge until waiting until you roasted it. I would fill and bleed the coolant system properly as per the Nissan manual and then carry out your informed diagnoses. If there is no oil in the coolant or any coolant in the oil you may have got lucky, however like TR I suspect that it may be the head gasket. Alex.

to the forum.

6mm x 1.5 if I recall. You will get them out of B&Q or any decent hardware store but take a sample with you to save multiple journeys. Alex.

to the forum.

Just go to Nissan with your 5 digit key number and they will cut a blank for you, thereafter you will have to get the alarm/immobilizer sorted depending on what model you have. Alex.

A little bit of carefully applied heat will do the job or simply just replace them. Alex.

Was this before or after you swopped out the IPDM and the BCM ? If after, I would check that the fan motors are working, in fact I would check out the fan motors irrespective. Alex.

to the forum.

Welcome to the forum.

to the forum.

to the forum.

PM on it's way Stuart. Alex.

Stuart, there are tests and procedures to check out a starter motor, however it may be a plan just to remove the starter motor and bench test it. Guaranteed fully working pre-owned starter motors are in stock if required. Alex.

to the forum.