Jump to content

Anyone's washer jets freeze this morning???


Recommended Posts

Posted

I'm not sure if its the fact that the jets are mounted on the wipers but mine remained frozen for my 55mile commute to work this morning - which resulted in me being able to see not a lot out of the windscreen during my commute on the motorway.

 

Anyone else get this???

Posted

I used to stay out in the countryside and it was the biggest bain of my life travelling into work when it was freezing as the washers would never work.

 

I always thought why don't they put a thin heating element within the hose and washer head to prevent it freezing? Would only take a couple of degrees of heat to prevent freezing or unfreeze the skooshers when your driving.

 

Has any car manufacturer thought of this already or am I sitting on a goldmine of an idea :snack:

 

Now due to underground car parking I don't have these hassles :yahoo:

Posted

I found spraying the nozzles with deicer helps getting the squirt out a wee bit faster. Although it doesn't help much if the pipes and tubes are properly frozen

Posted

yeah me too. Slept out last night so car wasn't in his garage bed and washers never defrosted the whole 45 min journey in. The last bit is blinding sun and it was a bit dodgy to say the least........ :blush:

Posted

Am I the only one that goes round all the windows with warm water before I start her up? I then let the car (and the seat ;)) warm up before going over the washer tubes again with warm water. I then give the washers a go before I finally set off. That way I have no probs.

Posted
My headlamp washers froze up last year and stayed stuck out like 2 eyes on stalks. Hasn't happened yet this year.

 

Mine does that at the first sign of cold. My petrol flap sticks out a bit when its cold aswell :wacko:

Posted
Am I the only one that goes round all the windows with warm water before I start her up? I then let the car (and the seat ;)) warm up before going over the washer tubes again with warm water. I then give the washers a go before I finally set off. That way I have no probs.

 

not good man, if its -5 like it is here today and the warm water is 30degrees thats a 35degree difference and its enough to cause thermal shock to the windows and crack them. IMO of course. :drunk:

Posted
Am I the only one that goes round all the windows with warm water before I start her up? I then let the car (and the seat ;)) warm up before going over the washer tubes again with warm water. I then give the washers a go before I finally set off. That way I have no probs.

 

not good man, if its -5 like it is here today and the warm water is 30degrees thats a 35degree difference and its enough to cause thermal shock to the windows and crack them. IMO of course. :drunk:

 

better off using mostly cold water. its warm enough to get rid of the ice normally so you can get in and get her running :shrug:

Posted

As this is the first winter with my Zed, I have found that not being able to open the boot as its frozen up a tad annoying, I have had to poke everything in from the cabin :lol:

Posted

you should mix the screen wash has its advised on the bottle, if you hake it too strong it will turn into a clear jelly like goo in your washer bottle and could the cause blockage problems, and it really starts to smell

Posted

The stuff I have just bought in halfods can be used without water in extreme winter conditions and its florescent green which is cool. As for the heated jets, I had an Omega MV6 with heated jets and I believe trace heated pipework. Still froze up but thawed after about 5 mins.

Posted
The stuff I have just bought in halfods can be used without water in extreme winter conditions and its florescent green which is cool. As for the heated jets, I had an Omega MV6 with heated jets and I believe trace heated pipework. Still froze up but thawed after about 5 mins.

 

God i tried that stuff and hated it!!! could they not do it transparent??? :lol:

 

I always use concentrate stuff (never diluted) and never had any probs whatsoever... actually just got back from Goldsborough near harrogate where i stayed fr-sat and there was 5-10 inches of snow and -3. Wiper jet washers and head lamp jet washers were working just fine. :thumbs:

 

For frosty mornings a jug of tap water loosens up the drivers window from the rubber seal (mine is a roadster) and then 10mins on idle with ac on at 25 degrees and heated seat and heated rear window/mirrors on as well. Then all good to go! ;)

Posted

I couldn't get into my car on Saturday morning. everything was frozen solid, none of the handles worked :rant:

After about 15 mins of scraping and spraying with deicer the passenger door finally opened (window didn't drop though) once the engine was started things moved a bit more quickly but I still couldn't get into the drivers side...

I took off the door card and lubed all the window and lock mechanism I could get to but not sure if it will help...

 

Washer jets stayed frozen all day, I had to keep leaning out the window and squirting volvic water on the windscreen! :scare: I tried to do this once on the move (only going slowly, there was no where to stop and I couldn't see anything!) and didn't try again after I got a soaking arm and leg for my troubles...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...