ZMANALEX

Only 3 x HR kits left in stock.

Only 1 x DE set left in stock. More due into stock this week.

Please read my last message, lock out plates can not be used with the toe bolts. Just head to an informed geo shop with bolts and template in hand

Okay, let's take a step back. You have fitted camber adjusting arms to the rear so that should take care of the camber, and you can also fit lock out plates to these. If you are running the stock rear spring carriers then you can not fit standard adjustable toe arms. If you want adjustable toe arms on the rear, you will require something like the image below, (these are what I run) and also use lock out plates, however these are expensive and overkill for your application. Perhaps in hindsight you should have bought a pair of camber arms and a set of toe bolts as a kit. However the toe bolts are available on there own, but please note that the bolt hole in the subframe will require elongated using a template which should be supplied with the bolts, you can not use lock out plates with these bolts. https://www.tarmacsportz.co.uk/spc-performance-nissan-350z-02-08-rear-camber-toe-bolts-pair.html

Yeah, they will do, however, I am not a fan of Driftwork stuff but they will do the job of getting your geo dialed back in. What brand of Camber arms did you buy?

This is what you require to lock the toe and traction.

No drilling required for the lock outs, they simply replace the snail cam adjusters.

Adjustable rear toe arms and lock out kits for rear toe and rear camber would be a good plan.

I never run standard tyre pressures however I believe they are 35psi front and rear when cold on Rays with standard size tyres.

It is cosmetic but it also does does tidy and seal the whole process up. Expensive new and very scarce preowned as they are difficult to remove without damaging. if you are having a new windscreen fitted then make sure that they replace all the relevant rubbers as they will also be covered by your insurance.

Sorry mate but I am sold out of these items at the minute I am afraid. However thank you for your enquiry.

I may have a fully working ECU in stock for your HR. If you send over the numbers on your ECU I will try and match up.

Bank 2, as it is the lean side on FI 350 motors. Best to use a Bosch stand alone sensor.

This is my set up. The twin carbon pod has been on the car for 15 years and still looks like new.

Coupe and Roadster use the same Y pipe.

It is a breather pipe and I have them in stock. Very easy to replace.

PM received and replied to:

I may have this mechanism in stock, but would have to check as I sold one last week. Drop me a PM if I can help further.

PM on its way shortly.

I do not think that there is a specific pod for the 350. I have always used aftermarket, some are a perfect fit whilst others require a small amount of fettling. It is only a £10.00 piece of plastic.

No point in replacing like for like, and have the same failure in later life. These are a far superior aftermarket version with neoprene internal seals which should not wear or fail allowing engine oil to pass into the spark plug aperture. if you want a set sent out, just drop me a PM. In stock and good to go same/next day.

I should have this in stock.

https://www.ebay.co.uk/sch/i.html?_from=R40&_trksid=p2334524.m570.l1313&_nkw=52mm+pillar+pod&_sacat=0&LH_TitleDesc=0&_odkw=62mm+pillar+pod&_osacat=0

Remove the scuttle panel.

Behind the battery within the IPDM unit.