ZMANALEX

Just lift the bonnet and check whether it has one air filter box or two, simples

Does your car have the two air intakes with the two air filter boxes? There are a lot of the early cars running with the bulge bonnets so just because you have the bulge bonnet does not mean that you have the HR.

Is your 2007 a VQ35DE or the HR with the twin air intakes as both clutches work differently? Also what is the mileage? Alex.

Afraid not, but I have one in Perth All parts required can be shipped same/next day Alex

No, there is a set procedure for bleeding the coolant system. If you are draining and flushing the full system you will require 10 litres of premix. I would recommend that you get a fully qualified technician who knows his way round a 350Z to carry out this work for you, or otherwise this could well end in tears. Alex

Preowned in stock and good to go same/next day Alex

Sounds like your fuel reg. Put your hand on the fuel pipe next to the fuel reg valve and check for pulsing in rhythm with the noise. You will find it at the rear of the engine, driver's side. Alex

On the hoses going to the heater Good luck Alex

Probably the backing plate touching the inside of the disc. Just bend it slightly away from the disc. Alex

I think that you may be referring to the grab handle on the passenger side door. On stripping you will find that the retaining bolt has been wrenched from its fixing or the centre has came out the grab handle. If it is the former, then it is just a case of reassmbly however I think that you may find that it will be the latter so a replacement grab handle will be required. Preowned grab handles in stock if required and good to go same/next day Drop me a PM if I can help you further Alex.

1 nut actually plus a few other bits and bobs

Steering wheel off Arran Alex

If they are almost at the end of there life then just replace them mate Toyo T1R 225/45 ZR18 95Y at only £100.00 each viewtopic.php?f=157&t=54730 In stock and good to go same/next day Drop me a PM if I can help you further: Alex.

If your lights have never been opened up then I would guess that the issue lies at the rear of the lamps. Check that you have an arch liner in place and also that the screw cap and seal is in situ on the rear of the lamp. Failing all that I have in stock good to go same/next day preowned and new prefacelift Xenon lamps and facelift Bi Xenon lamps Drop me a PM if I can help you further Alex

Nice one Gary Preowned air con compressors in stock for your application and good to go same/next day 12 month guarantee Drop me a PM if I can help you further mate Alex

No question about it, you are definately MAD. What price is a life? As per our previous PMs and the link to GTROC I guess that you now must realise why I only sell Eibach spacers. Your car, your life, your decision. Alex

You will require a new slave cyl, braided line and fluid to fix this issue. All in stock and good to go same/next day viewtopic.php?f=157&t=57106 Drop me a PM if I can help you further Alex.

Are you mad?

If you are only doing one side you will only require 1 cam box gasket. Most reuse the mid and lower plenum gaskets. Some RTV as per evilscorp post Alex

Nope, just 2 new cam box gaskets, £11.00 each if you require them

Arran, I would not worry to much about the noise from the steering with the engine switched off mate. Fit the front drop links and nuts that I sent you and take if from there. If you are still getting front suspension knocks then have a close look at the compression rod bushes and all the ball joints, especially the compression rod ball joint and the hub carrier ball joint. All bushes and ball joints in stock if required Alex

http://trackscotland.co.uk/booking/inde ... ducts_id=8 Only 7 spaces left at the moment. This will be a sell out so you you will have to be quick Alex

The 6 pin female connector is part ot the main front harness and is not part of the headlight wiring looms on the rear of the headlight. I have these in stock but would have to chop them as they are part of a wiring loom. Are you sure that you really require these?

Thanks for the referrals guys All parts in stock and good to go same/next day except the pollen filter as the Zed does not have one Drop me a PM if I can help you further Mike. Alex

You can use your bung in the knowledge that it will cause no harm Alex