ZMANALEX
-
Posts
15,067 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Everything posted by ZMANALEX
-
I doubt very much if the JWT will fit a RHD motor for the reasons previously given.
-
So you got there Kevin and back again How did the coolant issue hold up ? Alex.
-
I think that it just may be a yes as the scare mongering is now all past, a card which in my opinion they played to early. There are many who are still undecided and who will probably just decide once they are in the polling stations. It will be extremely close but I think it will be a YES, just.
-
Pull the cover away from the "pump" and release both the clips with a small screwdriver and the cover and jet will slip out. Alex
-
Thanks guys: Plenty in stock benmo. Just drop me a PM if I can help further. Alex.
-
to the forum.
-
to the forum.
-
to the forum
-
Yes, it is a motorised adjustment and is triggered by the movement of the rear anti roll bar.
-
£50.00 for a pair of fuel dampers. Th fuel dampers are not known for total failure, however the noise can be irritating. Alex.
-
As Chris has said it is your headlamp levelling sensor. Watch and not damage it as they cost over £500.00. Alex.
-
Sounds like fuel damper. Plenty pre-owned in stock if required. Alex.
-
to the forum.
-
PM received and replied to. In stock and good to go same/next day. Alex.
-
I should have a pre-owned OEM in stock. Just drop me a PM if I can help further. Alex.
-
to the forum.
-
to the forum.
-
to the forum.
-
to the forum.
-
APS give you the option of International, American or Australian as far as I know.
-
My Hermes worked for me the other day. Appear to be cheap and reliable but not fast. I used UK Mail for 7 years with very few issues, Fedex are good but not the cheapest. Alex.
-
Pm received and replied to. Alex.
-
Good luck with that, however unfortunately I can't see that working.
-
Remember that the manifold is cast.
-
If it is the end that I think it is then mole grips or vice grips should do the trick, however you may have to chop off the male rounded end and fit a new one using a flaring tool. Alex.