Adam B
-
Posts
240 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Everything posted by Adam B
-
took my oem skirts off, made it much easier and was able to clean all the crud out that had built up inside.
-
LOL Fit a magnet to your fuel line for another 20bhp while your at it. Needed a laugh thanks.
-
I`ll take the rears if that helps?
-
Had same problem on mine, gets worse the more you drive it. As stated above It was the slave cylinder, return spring had snapped inside. New cylinder, fresh fluid and a bleed, job done. Its not a squeaking gate hinge, I would not recommend wd40 either.
-
Mine had gone as well, replaced with aftermarket [ultra racing]. Be warned there are two mounting brackets either end which can rust out as well. Snapped a bolt on mine trying to get it off, had to drill out, which was fun.
-
Massive thankyou to all at Torqen. Despite supplier problems and a few issues that were completly out of there control they`re tenacity and patience with my whinging got everything sorted. Helpful and informative. Highly recommended. Thanks Torqen
-
Does sound like its burning oil, when its dangerously low oil pressure will drop under hard cornering as pickup becomes dry. Obviously damage is being done at this point. Keep an eye on it. Glad its not just me that hates the diptick design. Either a massive leak, obvious, or rings, valve seats etc. Do you leave a blue cloud behind you?
-
-
Hello and welcome
-
If it has one intake/filter its not the later spec power. 308bhp model had twin intakes.
-
Same problem on mine as above, arm fell off but had to grind bush off of shaft in the end. Be aware.
-
Of course , I`ll paypal now. Where should I send the money?
-
As far as I can tell they`re rear traction arms? If they are I`ll take them bud. Paypal ok?. Posted please. I`ll PM details on your reply Thanks
-
desperately needs a wash but I like these
-
Hello and welcome. Don`t recognize reg. Was it a local car or did you travel to get it?
-
Bought and received front camber arms for my z. Very nice bit of kit for the money. Does anyone have an assembly guide? Think I got it figured out but don`t want to f@#k anything up, grease or no grease etc Posted on driftworks but no reply. Any guidance much appreciated
-
-
Mines been sat in the garage since I took it off. Didn`t realize they`re worth so much!!!
-
Bodyshop should be able to supply hardware if they`re a competent outfit. Unless you need specialist components.
-
When mine was fitted the problem was opposite, bite point right on the floor. Adjustment of the pedal cured mine
-
Mountain Attack. 9am Sunday morning. Somewhere in South Wales
-
*** TORQEN *** 350z DE DIY Rocker cover repair kit
Adam B replied to Adrian@TORQEN's topic in TORQEN
Need this kit also, oil plug holes full of oil. -
like wise, drivers side only, side bolster torn. Free to collector 2005. Manual Cloth seat good airbags
