ZMANALEX

Indeed I do, just drop me a PM if I can help further.

Yes, easy to fit replacement but there is a knack to getting the old one off without damaging it. Let me know if you require a replacement and I will check what I have in the shop. Sold 2 today so not sure what I have left.

This what you are looking for?

Worth minimum of £550.00 Steve, perhaps considerably more if some one needs one. The cost for a gearbox overhaul is £1500.00 so £550.00 for a good fault free box is a steal. Don't listen to those low ballers.

Get the car on a flat bed ramp and carry out the bounce test and at the same time soak all the underneath moving parts with WD40 or similar. Continue bouncing and spraying until the tone of the squeak changes or disappears.

Sorry Luke but it is a no to both questions I am afraid.

to the forum, lovely looking car.

Indeed I do, however collection only from PH2 6EZ

PM received and replied to: Replaced loads of staked UJs in days gone by, but never had to replace a 350 UJ. however the principles are the same. They simply press out and do not require any cutting and then carefully press the new one in and as you say use an internal snap ring. Available on line, however best to measure accurately with a vernier to get the correct size and go for the ones with the grease nipple

Paul, Please drop me a PM and refresh me with what Roadster trim parts you require. I will have all the trim parts in stock. I also have a PAS pump in stock and associated new belts.

All parts are in stock if you decide to bid/buy.

to the forum.

Very simple to replace. If you want a switch sent out then just drop me a PM @ZMANALEX

Buyer beware. If it was a cheap fix, don't you think that the dealer would have fixed it? If you feel lucky, make the dealer an offer.

Here you go Paul, just drop me a PM if I can help further.

I will grab some pics when over at the shop tomorrow for you.

OEM Facelift front bumpers in silver are in stock, but collection only I am afraid from the shop at PH2 6EZ.

Here you go, Totally mint with no rust or scratches.

If you do not have the equipment or required skills to check out the electrics, i would firstly just try another switch. Is the VDC locked on or off? Switches and any other required parts to fix your issues are in stock if required.

I have a silver Roadster boot lid finished in silver in stock at the minute. Just drop me a PM if I can help further. I will grab some pictures when over at the shop later today.

I can help you with this, and I know exactly what you want as I have supplied a few of these. Cutting out and shipping to you is not a problem.

I can do this for you and shipping to Spain is not a problem. Just drop me a PM if you wish to -proceed.

In stock mate.

I should have mate, let me check in the shop tomorrow.

** NOW SOLD **