ZMANALEX
-
Posts
14,760 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Everything posted by ZMANALEX
-
There is no timing belt on the VQ35DE only a timing chain. Post up a pix of the 22mm issue.
-
Doesn't make a lot of sense, however I should have the plastic bits in stock as I am dismantling 4 x 350Zs at the moment. Just drop me a PM with a picture of the trim part that you require. Alex.
-
All in your head.
-
to the forum.
-
to the forum.
-
Fully working pre owned thermostats are in stock and good to go same/next day if required. Just drop me a PM if I can help further.
-
New 370Z owner with a few questions!
ZMANALEX replied to Southpaw89's topic in Introductions & Welcome Messages
to the forum. -
The Litchfield stage 5 costs just under 15K. If you want the forged stuff then add on a further £4200.00
-
to the forum
-
350Z 40th anniversary new and pre owned alloys in stock at the moment and good to go same/next day. Just drop me a PM if I can help further. Alex.
-
Young' From Up Norf (East)
ZMANALEX replied to Mikey Thompson's topic in Introductions & Welcome Messages
to the forum -
Any mild steel or high tensile or stainless will do the job, however best to use a "shoulder" bolt and not one threaded all the way.
-
to the forum
-
Rob, if you can't get access with a small angle grinder, dremel or nut splitter then you will just have to use a good sharp cold chisel. In the past I have managed with a small nut splitter but you will have to make room by moving the looms slightly to the side. You could also try jacking the car up so that the suspension is hanging which will put a bit of load on the nut which may just be enough to rattle the nut off with an impact gun.
-
That would be the A pillar trims for the front screen.
-
As per my first post, I would certainly make sure that both your cam sensors are good, however I know that Keyser would not sell you a duff sensor deliberately, but you always run the risk when fitting used sensors. Alex.
-
Not necessarily. However if you have replaced the cam sensors properly with proper fully working sensors, then my next port of call would be to try a crank sensor. Where did you buy the cam sensors and were they genuine Nissan.?
-
Providing your cam sensors are okay, I would be perhaps looking at the crank sensor. Alex.
-
Good luck with your purchase, however I would have thought that you would have been better checking out more important items other than a key and a phone cable. Read the buyers guide thoroughly.
-
What Dan and Will have said. Brave man indeed buying blind.
-
to the forum.
-
PM received and replied to.
