GIXXERUK

best induction kit for a vr6 vw is a BMC CDA - that sound awesome had one myself on a corrado

you're not alone

they look awesome lexx really compliment the white

Near stoke on the M6 this morning

price ?

Nice work there tim

No mate back pressure is causing the gases to hold in the system which make the exhaust valves work harder, e.g. if you take the exhaust off or make it too free flowing you will lose torque basically your allowing gases out quicker than they can get in, so the system is weak what i wanted to know was with the bungs in does it make the exhaust rumble under the pressure

deeper - less tinny - louder ? i'm not so sure do the bungs cause back pressure ? do they make the sound quieter but the exhaust its self louder - if that makes sense, i know they do that on my bike

def seems like the same exhaust, the k1's are not mm perfect as far as the level of the tails go pics n sound clips would be good will it quieten down when it carbons up ? most zorsts are a bit noisier when new as they resonate

sarnie is on holiday

very simple job, 10 mins, they are stuck on with double sided tape, so warm them with either hot water or a hair dryer to soften the glue then use some tooth floss to get under and pull them off car looks btw

Usage instructions for your products recently purchased. POORBOY’S WORLD SUPER SLICK & SUDS Shake well before use. Always try to wash your car when the surface is cool where possible, i.e. early morning or late evening. We recommend using a two bucket method with grit guards and at least 1 high quality wash mitt to effectively clean your vehicle whilst removing as much risk of scratching your paint as possible. (Two mitts are ideal to designate one to the lower areas of your bodywork and the other to the main panels and glass) Poorboy’s recommend using approx 1oz of product (approx 30ml) per car and we find that unlike other products you don’t need to use more just to get enough suds to actually wash your car! (If you live in a hard water area you may have to use more product) Thoroughly soak the mitt in the wash solution before starting, then working on a panel at a time wash gently in a back and forth motion to prevent surface marring and swirl marks, rinse well after each section remembering to rinse the mitt after each panel in a separate bucket of clean water (+ grit guard ideally). After a final rinse down using low pressure water (straight out of the hose end this encourages more water to “sheetâ€

Exactly! 3 fools arsing around is very entertaining. Reviews of 1.8 Mondeos aren't entertaining. Bring on powerslides, stupid challenges and some fat bald vs slow posh vs small spikey hair banter. and the competition on a sunday night at 8pm is ......................

..........

you cant single out the 2nd hand value of the Z, the country is in a mini recession the bigger picture is the 2nd value of everything is dropping, the only things on the rise are interest rates and unemployment everyone is scared of spending so its more difficult to sell so people are dropping their prices

Phew ! time to stop worrying and start spending, everything is sorted

? You wont pass an mot without them ?

its all a bit american, a 168 for your sidelight bulb

looks good but needs spacers and lowering

http://www.350z-tech.com/zwiki/Service

Not just zeds, houses, other cars...... basically the 2nd hand value of everything has dropped and is continuing to do so

Very neat install