Jump to content

Ian

Members
  • Posts

    17,144
  • Joined

  • Last visited

Everything posted by Ian

  1. We are @*!# but atleast we know out place Unlike England the bestest awesomest team in the world
  2. Ian

    I girled it.

    Anything single exit. I used to have decats, straight piece y-pipe & a single exit with no silencer
  3. 1966? Don't think I have ever heard them mention that before
  4. Would have been even more boring if England were in it
  5. SOLD
  6. I believe the term your looking for is STOLEN or ROBBED or DAYLIGHT ROBBERY or just plain old RAPE
  7. Ian

    headers

    Aslong as you buy a decent branded pair you should have no issues with cracking. Just avoid ebay tat & Japspeed
  8. Ian

    question time people!

    Yup. The wheels me & Chris are talking about are the set that I've conned him into buying
  9. Ian

    headers

    Headers aren't value for performance. They just aren't. They're a total PITA to fit with the engine still in, it's possible but expensive. Headers are something you should consider alongside cams as part of a proper N/A build, they're unlikely to give you more than 10bhp for your £2k otherwise. The fact that you've asked this question suggests that you shouldn't consider such a build until you do a LOT more research. DB Its not though. People will happily pay £8-900 for an exhaust setup & gain 3-4 HP. A set of headers & installation will cost around the same & give better gains. Most people just begrudge paying the higher labour charges for fitting. Just get a decent brand of header & once they are in then its all good. An engine out job? No. It is easier to do it with the engine out but its perfectly doable with the engine in place. My setup was DC headers which cost me £75 on ebay (OK they were cheap, but DC's wont break the bank to buy new) & 10 Hours labour costing £400. Thats £475, Not much more than buying a pair of Berks
  10. 2nd post eh? Im getting an early call for troll or absolute assbiscuit He drives a Jag now
  11. As above http://www.crowderscustomizing.com/E-Br ... s/2023.htm
  12. Ian

    question time people!

    Especially as the ones in my FS thread are a lower offset & seem to sit further in
  13. Ian

    question time people!

    They would fit on a normal z
  14. Ian

    question time people!

    Yeah, these came off a Z viewtopic.php?f=9&t=59013 ^^ some pics of them on the car of the person who tricked me into taking them & also raped me
  15. Ian

    question time people!

    I know I buy wheels that don't fit so ignore me
  16. Ian

    question time people!

    275s on a 9.5" wheel? Most people run 245s on 9.5" front wheels with a 275 on a 10.5" rear If it was me I'd go 235/255 combo
×
×
  • Create New...