ZMANALEX
-
Posts
14,760 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Everything posted by ZMANALEX
-
Need Help with buying the right clutch... 57 plate
ZMANALEX replied to Christian350z's topic in 350Z General
Unfortunately I do not think that will happen. A refund is probably all that the OP will get. Good luck -
Need Help with buying the right clutch... 57 plate
ZMANALEX replied to Christian350z's topic in 350Z General
Unfortunately they will not be able to supply a dual mass fly for an HR at the same price as the DE and the clutch kit is more expensive as well and it does not come with a new clutch release bearing. Alex -
Dual Induction or air filters, any sort, 2007+ HR
ZMANALEX replied to Christian350z's topic in Wanted
Preowned CAIs in stock for 350 HR. Nismo and JWT Both will give you a more throaty effect Good to go same/next day Alex -
to the forum Antonio
-
Cosworth Performance Panel Filters are also £29.95. Both Cosworth and HKS PPF are in stock and good to go same/next day Alex
-
If your car is a VQ35DE then if you replace the clutch slave cyl. and fluid and fit a braided clutch line then that should sort your problem. All parts in stock and good to go same/next day Alex
-
There is a NTSB on this issue for cars under manufacturers warranty. Step 1: Lub and rotate: Step 2: Replace axle slide with upgraded slide. The slides have code numbers on them so that Nissan technicians know if they have been upgraded at any time Alex
-
DBA T3 Rotors are the way to go Dave Rear Genuine Brembo aftermarket pads also in stock at £34.95 viewtopic.php?f=157&t=58518 http://vimeo.com/24192150 viewtopic.php?f=157&t=55107 All in stock and good to go same/next day Alex
-
I have in stock the HKS Performance Panel Filters for your 05 350Z priced at £29.95. Alex
-
I have done a few, some with engine in and some with engine out. Why are you considering replacing the headers? Alex
-
All parts in stock
-
In stock and good to go same/next day. Liner fixings also in stock Alex
-
They will fit, however you will have to swop over the drop glass Alex
-
The clutch release bearing only turns when the clutch is depressed
-
Why is it that when people ask for a valuation and they get it, that they are more than often offended or disappointed with the answers they get. You will be very lucky indeed if you get a residual of 8K. Alex
-
Providing it is a VQ35DE model, the clutch slave cyl is located on the L/H side of the gearbox to the front. Alex
-
If your clutch fluid was that low then I would suspect that you may have a leak so best to get under the car and pull the rubber boot from the slave cyl to check if the leaked fluid is trapped in there. All recommended quality fluids and slave cyls in stock and good to go same/next day Alex
-
Alex do you have an alternative email for A1 japspares? Getting failure notice on the one which is on their website and cannot get the part request page to work either! If not will try phoning Monday. Best to contact them by phone. 0161 682 2221
-
Was out : but back now Sorry not got one, however A1 Jap spares will have them Ask for Omar and mention my name Alex
-
The garage told me that you were paying for it I think that you should give them a call and get that point clerified. If they are paying for it, then insist on a new chassis leg. Alex.
-
Tell Ross at Japex that you are buying the parts from me and ask him to cut you a deal at £200.00 labour.
-
And don't forget the flywheel as Neil has said I keep in stock the exact same fly that Nissan have quoted you on, however I only charge £345.00 Expect to pay around £200.00 for fitting. Alex.
-
Exedy is the clutch kit to go for In stock and good to go same/next day viewtopic.php?f=157&t=27436 Alex
-
In stock and good to go same/next day Alex
-
The dealer must be having a laugh. Do not accept this engine under any circumstances. Alex