ZMANALEX

Nice one Gary Preowned air con compressors in stock for your application and good to go same/next day 12 month guarantee Drop me a PM if I can help you further mate Alex

No question about it, you are definately MAD. What price is a life? As per our previous PMs and the link to GTROC I guess that you now must realise why I only sell Eibach spacers. Your car, your life, your decision. Alex

You will require a new slave cyl, braided line and fluid to fix this issue. All in stock and good to go same/next day viewtopic.php?f=157&t=57106 Drop me a PM if I can help you further Alex.

Are you mad?

If you are only doing one side you will only require 1 cam box gasket. Most reuse the mid and lower plenum gaskets. Some RTV as per evilscorp post Alex

Nope, just 2 new cam box gaskets, £11.00 each if you require them

Arran, I would not worry to much about the noise from the steering with the engine switched off mate. Fit the front drop links and nuts that I sent you and take if from there. If you are still getting front suspension knocks then have a close look at the compression rod bushes and all the ball joints, especially the compression rod ball joint and the hub carrier ball joint. All bushes and ball joints in stock if required Alex

http://trackscotland.co.uk/booking/inde ... ducts_id=8 Only 7 spaces left at the moment. This will be a sell out so you you will have to be quick Alex

The 6 pin female connector is part ot the main front harness and is not part of the headlight wiring looms on the rear of the headlight. I have these in stock but would have to chop them as they are part of a wiring loom. Are you sure that you really require these?

Thanks for the referrals guys All parts in stock and good to go same/next day except the pollen filter as the Zed does not have one Drop me a PM if I can help you further Mike. Alex

You can use your bung in the knowledge that it will cause no harm Alex

I have both Alex

Ben, Best to delete all the archived codes and start with a clean sheet. 0350 is the one that may return as it relates to Ignition Coil Malfunction. New and preowned coil packs in stock New Denso Iridium spark plugs in stock All good to go same/next day Drop me a PM if I can help you further. Alex

6 in stock

8 OEM preowned bonnets in stock Drop me a PM if I can help you further Alex

Clive, I may have a preowned OEM rear box in stock if you are on an economy drive. Let me know and I will have a look:thumbs: Alex.

Hi and to the forum

You will only require the shock disconnected at the bottom to check the resistance

I now run MPSS with the XL sidewalls (nitrogen filled) on my R35. They are not runflats and I have experimented with various pressures but I am now back to the recommended pressure of 200 Kpa. Alex

Replacing a rocker cover will take circa 1hr. The plenum has to be removed but the inlet manifold does not Alex

Running a N/A 350Z at the ring as a beginner I would start with the following. Decent tyres: R888 or similar, providing it is not peeing it down. Eibach sway bars front and rear (anti roll bars) RBF 600/660 brake fluid and a set of braided lines Full geometry check and adjust: Some CAT driver training. R888s, Eibach sways, 600/660 fluids and lines all in stock and good to go same/next day. Drop me a PM if I can help you further: Alex

Disconnect the shock and check for resistance. Is the car sitting level? Are the rear sub frame bushes in good condition? Are the rear suspension arm bushes in good condition?

Preowned in stock and good to go same/next day Drop me a PM if I can help you further Alex

As far as I can remember there was not a recall in the UK. Alex

+ 1