ZMANALEX

You would be best fitting hub-centric spacers that already have the studs fitted.

There is no definitive answer to your question as the spline is tapered. However the diameter of the hole on the hub will be 14.32 mm

to the forum

Cusco do them. ditto:

to the forum.

to the forum.

I think that you will find that the splines are also the same front to rear.

You have already asked this question. http://www.350z-uk.com/topic/116491-350z-rear-wheel-stud-size/

to the forum.

They are slightly different lengths, however the diameters are the same.

Plenty in stock if you want replacements.

Genuine Nissan. Images sent and should be in your inbox. Alex.

Bi Xenons in stock if you fancy an upgrade.

to the forum.

back Steve.

The HR is different from the DE

to the forum.

hi it is a roadster, and i am referring to the rear roof clip that pull roof back of the roof down to seal it to the lift up flap Still not quite sure what you are trying to say, can you rephrase that please.

to the forum, and in answer to your question, just adjust the striker plate which is fitted to the front carbon composite panel. Edit: are you referring to the bonnet or the boot ? Also coupe or roadster ?

to the forum.

to the forum.

to the forum.

to the forum.

Hi Stan, Hope you and Lucy are well. What would happen up here in Scotland is that the wide boys would arrange a 24 hour test drive with there local Ford distributor. I am sure that you and Lucy could convince them that you are respectable potential customers. Also if you are lucky then they may even allow you the test on their insurance. Good luck mate and belated happy birthday wishes. Alex.

Luke that is not the banana arm and not what you need. # 10/12 from the schematic is what you require Plenty in stock. Alex.