H5

The following is the correct procedure for resetting the ECU See the red text in Step 3 which is crucial to success. 350Z ECU Resetting Procedures Timing is extremely critical. If it is NOT DONE within the specify time, the ECU will not reset and the Check Engine Light (CEL) will continue to remain ON. A stop watch or an analog clock with a second?s needle will be useful. Operational Procedure 1. Confirm that accelerator pedal is fully released, turn ignition switch ?ON? and wait 3 seconds. 2. Repeat the following steps (2a and 2b) procedures quickly five times within 5 seconds. 2a. Fully depress the accelerator pedal (HARD). 2b. Fully release the accelerator pedal. 3. Wait 7 seconds**, fully depress the accelerator pedal and keep it for approx. 10 seconds until the CEL starts blinking. **The 7 seconds starts from the end of the 5 seconds period above it does NOT start from the 5th release of the accelerator pedal. 4. Fully release the accelerator pedal (while the CEL is still blinking) 5. Wait about 10 second. 6. Fully depress the accelerator pedal and keep it for more than 10 seconds. 7. Fully release the accelerator pedal (The CEL light will continue to blink but at a a faster rate). 8. Turn ignition switch to ?OFF? position and now you can start the car. The CEL light should be gone. If the CEL light continues to remain ON, repeat the above steps. Timing is EXTREMELY critical to resetting the ECU.

http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... 0451057921

Do you want to try the ECU reset? I can search and post the details here?

Sounds like it may have gone into some sort of limp mode. What do you get if you turn the key to the ign position but don't start?

Welcome

Welcome

Welcome

Welcome

Welcome Still not found anything better then!

Welcome

Lovely!

Thread tidied at sellers request.

How long before what? You strip it, clay it, polish it, seal it, wax it....... All asap

Oh yes, the current favourites!!

Good luck!!

Nice combo there. I would say that though!

CG Citrus Wash n Gloss has two dilution ratios - one to strip, one to clean......

Very nice!

Shhhh dont say that! you may put people off Apart from Nurrish! No times yet, will pull it all together over the weekend. I can't be there on Sunday at the moment no, would love to if that's the lions share of the attendance.

Good luck!

Come on people, great chance to meet other members here!

Here viewtopic.php?f=27&t=13074&hilit=install

I do yep, will search for it when I get in front of a PC and put a link up. It is a stealth one this time. Be good to see you at some meets, check the section out.

Likewise, kinda! Nice gains

Interesting - so what are the numerical shifts? before and after bhp and torque (unless I've missed it on those pics?) That's what I like about the gear knob, the fact it's in keeping and doesn't look aftermarket.