Jump to content

cs2000

Members
  • Posts

    2,628
  • Joined

  • Last visited

Everything posted by cs2000

  1. BCM. but I doubt its that seeing as they don't work at all. Normally a busted lights section in the BCM just kills the auto on-off dome lights facility. Secret fuse box by the battery perhaps?
  2. cs2000

    P0340

    Correct, bank 1 is drivers side.
  3. Always good to hear good comments about Sly. As I say, hes sorted me out again and (I know im going to get moaned at for traveling long distances to get work done, but im seeing him (face to face for the first time) in a little over a months time for some more work! Its a 189 mile round trip for me but theres some great roads just around the area, nice wide and open and sly is a top bloke. Shame his garage is almost impossible to find, or at least it was for me the first time at 2AM in the dark with a security guard following me in his van!
  4. Not 100% on your question, but in the passenger side A pillar there's a red, black and pink wire. Red and black are pos and neg at all times (even when car is off) and pink becomes live when a door is opened. Just be careful tapping into that circuit with regards to overloading the BCM.
  5. Recently got a quote for me to fix a dent and a 1 inch scratch on rear wheel arch is £150, may help you in gauging.
  6. Brill. So... SET1 - With Badgeronimous(AJRFulton) Asked to post to Lambo SET2 - With bakseedaa SET3 - With apcarter SET4 - With 370Mike Ive removed Dogfather, he still hasn't responded to anyone's PM's requesting his address so after this the list is clear. Hang onto your DVD's in case someone else needs them
  7. both sides can be accessed without totally removing the bumper, but you do have to undo 95% of the fixings to give it enough flex.
  8. I could be being stupid, not with the car atm, but isn't that where the headlamp leveller thing is, I could ofcourse be thinking of my Celica, which I probably am.
  9. Yes, id agree with docwra, limp mode and misfire are very different. But limp mode still makes the car run like balls. Probably difficult to understand unless you've experienced both. Im not that clued up on it, but it does severely limit engine RPM, throttle inputs are delayed and speed is restricted, im guessing ignition is retarded too but it may not need to do that since the car is 'fly by wire'. Mine felt bloody awful the few times I've been in it, but It wont show on a ODBII scanner.
  10. So, as we stand now... 1. 370Mike 2. Lambo 3. Dogfather SET1 - With Badgeronimous(AJRFulton) Asked to post to Lambo SET2 - With bakseedaa SET3 - With apcarter SET4 - With Will370z Asked to post to 370Mike That clears it up Can you please PM Lambo, he is next on the list and send your DVD set off to him please? Will, would you mind sending yours to 370Mike, again, just drop him a PM and let us know how you get on Glad this is going well still and you guys are getting the updates. I feel bad for the issues however as yes, im saving you all £300+, but when the update disk dies it takes everything with it, you get no nav, no radio, no CD, etc and that would suck! Gladly, no-one has gotten stuck with this for more than a day orso apart from Andy as he was the guinea pig, but still sucks!
  11. I found it was a loose connection on the throttle pedal. Theres a little electric plug down there that senses what % throttle youre asking for. I guess the loose connection was occasionally sending sporadic values and the car immediately goes to limp mode as its the safest option for you and itself! I also did the idle valve relearn, throttle pedal reset, ecu reset and MAF clean, just because why not! Probably not the same for you but it sounds very very much like limp mode if it went away when you restarted the car. Finding the cause is the hard part. @ddcboyle - I also had/have that issue with a induction kit, there's a thread about it somewhere but seems they're all susceptible to it, something along the lines of the less restriction means more air is flowing over the sensor at those speeds than the factory airbox, car doesn't know what's happening and doesn't give the correct AFR so the engine dies. The only fool proof method is use the proper air box. Mine only does it once in a while, annoying (and dangerous sometimes) but not harmful I guess. It shouldn't cause low RPM once yours standing still though like the OP posted about.
  12. Limp mode? Ive entered it a few times for reasons ive now fixed, but it severely limits what the car can do and does feel like its broken, restarting the car always cleared it for me. Didn't help much trying to trace the issue however.
  13. Cheers mate, on my phone ATM so il add you later but they're yours. That's All folks. I may start these again early next year, depends how I feel, just want a break from them now, maybe find another thing I can improve with leds. Any suggestions?
  14. Yeah, no idea why but eventually it works, sorry for the hassle its giving you all. People seem to have to load it in chunks, no idea how many tries it takes though.
  15. Heh, yours are just drying (silicone) and testing, should have them out for you on mon, possibly tues Cheers Ballardpaul, added. Just 1 more slot remaining
  16. Gonna be taking a break from these for a while, I think with winter arriving soon anyway the market will die down a lot, plus I will have made 31 sets, need a break! So, on the first page there are 3 final slots, 1 if already occupied so there's a potential 2 left, these will be the last set I make for the foreseeable future, if you want them, get your name down now. Wont need payment until next month as I want to finish the orders I already have before I add more
  17. My neck of the woods, to the forum and in advance to Suffolk! lol
  18. Sorry guys, didn't notice I had messages, PM's incoming to you both
  19. Removed all of my posts mentioning our code too. im surprised the AudiSport one hasn't been removed yet as that's been floating about for ages.
  20. Oooooooh, maybe... AJRFulton - Did you get your set directly from me, or someone Fwd it onto you?> If yours came from me DVD 2 and 3 will not work and you need replacements, drop me a PM with you address. We were talking about it on page 2 and I couldn't remember who SET5 went to, perhaps its you?
×
×
  • Create New...