Keyser Posted December 4, 2012 Posted December 4, 2012 You know I said you had to be really careful polishing the top coat back? Well if someone in the ZedShed (so it was me or Bob) wasn't careful enough - I feel an annex to how to repair a bumper coming on Quote
Flex Posted December 4, 2012 Posted December 4, 2012 Well it's wrapped and ready to just test your skills out!! Quote
Keyser Posted December 4, 2012 Author Posted December 4, 2012 I reckon it was Chris, he's due one Oi no need for that!!! What "(so it was me or Bob)" actually means is I did it Bob's getting the blame I could have gone with it was Bob or I did consider " so to show you what happens when you c**k it up" but basically I spent to long trying to get a mark out in the corner and ended up with a small bit of primer showing the pic above is after it has been re-preped for paint. So Yes my bad folks I'm a man I can take it ... Quote
glrnet Posted December 4, 2012 Posted December 4, 2012 I reckon it was Chris, he's due one Oi no need for that!!! What "(so it was me or Bob)" actually means is I did it Bob's getting the blame I could have gone with it was Bob or I did consider " so to show you what happens when you c**k it up" but basically I spent to long trying to get a mark out in the corner and ended up with a small bit of primer showing the pic above is after it has been re-preped for paint. So Yes my bad folks I'm a man I can take it ... It was obvious, when it's Bob you take great pleasure in calling him a **** straightaway, you were too indecisive on this occasion Quote
Keyser Posted December 4, 2012 Author Posted December 4, 2012 I pick on Bob irrelevant of doing anything wrong or not - but he picks on me so all is fair @ Jim - I did 2 hours in the shed instead of 20mins on the prickly mat mate - but it's looking better If it dries and blends OK I'll tell you how I did it Quote
glrnet Posted December 4, 2012 Posted December 4, 2012 SMD would have preferred the prickly mat Quote
rtbiscuit Posted December 5, 2012 Posted December 5, 2012 good work mate, that is not easy to blend Quote
Chris`I Posted December 5, 2012 Posted December 5, 2012 Yup, gotta be careful with rotaries on sharp edges, takes no time to burn through. Result looks excellent though, if I didnt know better I'd say it was a setup How are you with high build primer? I know a bus that needs colour coding Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.