ZMANALEX

The rear pads, like the front have two pins holding the pads in place, and not one as suggested if you are running Brembo brakes.

Best to get the noise professionally diagnosed before considering additives etc. Alex

Andy, I have the main engine undertrays in stock mate with all the fasteners. These are brand new genuine Nissan undertrays. Drop me a PM if I can help you further mate. Alex

Hi and back to the forum mate:thumbs:

Hi and to the forum

Hi and to the forum

Here you go viewtopic.php?f=157&t=21691 viewtopic.php?f=157&t=21842 Alex.

May be the cv joint clicky axle issue, or perhaps the pads moving in the rear caliper. Alex

They are called body side roof mouldings, and I hope that you have deep pockets as they are circa £300.00 each. Alex.

I would not worry about this to much as air filters are replaced daily and CAI kits are fitted on a regular basis. You do not mention which type of filter or CAI that you have fitted. Perhaps it is a fitment issue or a simple reset may be required. Good idea to swop back to oem to check for comparisons Give me a shout if you are still having issues and I will send you links for the resets. Alex.

Bank one is R/H - Driver's side if RHD. Cam Position Sensor is positioned at the rear of the head. Alex.

Remove the tail lamps to get to the tail lamp bulb. Gently flick off the 3 black plastic bolt covers to expose the 3 retaining bolts. It is only a 5 minute job. Alex.

Tail Light Bulbs

Not quite my neck of the woods Chris. Why not run the above companies past Ewan at Clarks MS. Alex.

back mate

Here you go Phil viewtopic.php?f=157&t=50461 Alex.

Mark 3 in stock Brand new 7 Drive series. £120.00 Drop me a pm if I can help further Alex.

Hi and welcome to the forum.

I realize that Tom and no offence was taken mate, I was just letting you know that I was on the case but I have been extremely busy and today is manic. Everybody wants there parts yesterday Alex

It really does mate, it is a very straight forward job. If you also remove the two top thumb screws that hold the rad. in position then perhaps this may give you a bit more flexibility Also did you remember to disconnect the fan motor block connectors and you may also have to snip a couple of cable ties that are securing the looms. All should be quite obvious if you have a close look. Give me a shout back if you are still having issues. Alex.

Also best to gravity feed the fluid into the transmission So get a metre of 10/12mm hose and a small plastic funnel when you are at the store.

Hi and welcome to the forum. I stock quite a few G37 upgrades including: Eibach lowering springs Eibach sway bars. Eibach wheel spacers. DBA brake upgrades including rotors and pads. PowerGrid adjustable sway bar drop links. HKS and Cosworth Performance panel air filters. Let me know if I can help you further. Also what I do not have, I can source fairly quickly However I do not supply new exhausts so may be best to talk to Tarmac on that one. Alex.

Hi and welcome to the forum. Upgraded Clicky axle kits in stock. Let me know if I can help you further. Alex

Best level mate, for the reasons that you have stated 4 x axle stands

I am not a magician and neither are the posties I found one on Friday for you but have not had time to look for another. Can any one else help out Tom on this one