ZMANALEX

To please you Mother we can always revert

what happened to your old motto alex, in stock and good to go? I dont like this new one Time for a wee change Neil as I was recently reminded that it was becoming tiresome, so blame them. Step forward, you all know who you are. Actually I thought that it had went unnoticed.

There is a small wire that comes off the starter, make sure that it is connected. However, low mileage preowned starter motors in stock and ready for immediate shipping if required Alex.

Yes that is a very stooopid question Yer but whats the answer going to be? The answer will be NO

Yes that is a very stooopid question

Both sides in stock and ready for immediate shipping Alex.

Compression arms (banana) in stock and ready for immediate shipping Might have a wing, will have to check. Set of 1 month old 20" Fox Deep Dish RS 8s with as new Continental tyres. Front: 8.5JJ et25 114.3 255/30/20 Rears: 10JJ et30 114.3 275/30/20 Alex

These specific recalls appear to relate to '07 models, slave cylinder and alarm control module. Came out in April '08. See bottom of page 1 on this thread for copy of notice. viewtopic.php?f=28&t=13584&hilit=+recalls Thanks for that mate Alex

Are these issues not just NTSBs.? Don't recollect recalls on these issues. I had one last week where the concentric slave had failed and the clutch got contaminated with fluid. I fought my customers corner and we got 100% labour, a concentric slave, clutch plate and clutch cover all under warranty. The car was a 350Z, 2007, 29,000 miles, Full Nissan Service History. Alex

Looking real good Nico

Hi and welcome to the forum

Hi and welcome to the forum

Ferodo DS 2500 pads in stock. Performance Friction pads in stock, (various compounds available depending on intended use) Performance Friction Rotors in stock DBA Rotors in stock HKS braided lines in stock Motul RBF 600/660 fluids in stock. Most of this stuff can be found in my sub forum. viewforum.php?f=157 Please feel free to contact me for prices once you have decided what you want All in stock and available for immediate shipping. Alex.

Hi and welcome to the forum

Indeed it is a CVV Toby. Have you checked all your vacuum pipes and also that you have not nipped something between the spacer, in particular the oil catch rubber that is around the oil fill. Alex.

Welcome aboard Steven

Hi and welcome to the forum

I'll be on my second tank of V Power by then

Those were Eibach shallow nuts and not bolts/studs As far as I know the studs are not available from Eibach. Alex.

I have a preowned bonnet in grey and a tail gate in black. £150.00 + shipping at cost. Alex.

Coupe or Roadster? Alex.

PM received and replied to

Chris, There are two little plastic square fixings that push into the wing mate. Then two 6mm bolts screw into them. You will probably find that the plastic fixings are stripped or squashed PM me your addy and I will get two in the post to you. Alex.

Hi and welcome to the forum Chris.

Hi and welcome to the forum