lomoto

complete set for sale in The States http://cgi.ebay.com/ebaymotors/Nissan-3 ... enameZWDVW

will cost more than a grand !! you have to swop the disc's and lines as well as the calipers

10 min job , undo 4 screws that keep shroud around steering column, first pop out trim ring round ignition switch... then there are 4, 10mm head bolts that retain speedo assy to the steering column undo these (they are a bit fiddly and you will need a small ratchet with longish extension bar to get at the front ones ) and thats it just unplug the single electrical connector and the speedo assy will be in your hand !!

a nice wheel , smooth look to them

for sale new here if no-one has a spare to sell http://www.courtesyparts.com/Merchant2/ ... 2865-Z33SK

still slow , is this likely to last for a while ??

here's the only ones I have of the plenum

from what I can remember when I removed my center console , I think you will be OK with the 1cm requirement

Nice looking wheels Rob, will look good on the Zed I can recommended the Falken tyres also

I had something similar happen when I first had my car, I disconnected battery for about 30secs then reconnected been OK ever since Worth a try... just remember to lower both windows when you do the disconnect thing though

cool very cool by the look of the weather as well, you did a good job keeping it off the grass

out of interest, how many miles has your car covered?

turn the radio up

Just done a quick search on Ebay , about £6 for wheel bearings http://cgi.ebay.com/ebaymotors/NISSAN-W ... enameZWD1V or complete hub assy about £50 http://cgi.ebay.com/ebaymotors/Hub-Bear ... enameZWD1V

Its not easy at all, controlling the lack of spin and doing a proper launch is the hardest thing you can do in my opinion doing standing start sprints is the surest way to bollox a car

HOW MUCH FOR WHEEL BEARINGS I think I would ring round a few motor factors first before shelling out that sort of money

hows this for quick service Jim?? thread here http://www.350z-uk.com/forum/viewtopic ... ght=silver

Swap the front tyres, and magically the noise will disappear . This noise you describe is classic Zed tyre noise with the Bridgestone tyres fitted .I wouldn't replace with Bridgestones though

yep I was interested Andy

you can see the full version of this plus lots of other footage and different edits on "The Run " dvd... showing the Zed through the streets of Prague on full chat good viewing if you've not seen it

I've seen some Volks / Rays with bad corrosion on as well ,so price is no guarantee for quality of finish...

looking at them again , I think they are a steal at that money

I'd have been tempted if I hadnt got a set of rims already... they look nice wheels for the money