Pop-up bonnet light staying on

[stu1986]

Hi all

I took the bumper and headlights out and since I have the pop-up warning light is staying on now, why is this?

[Kev T]

I assume you removed the sensor connections to front bumper which makes the car think there is a fault, unfortunately you will have to go to a main dealer to get it reset, but dont worry it doesn't effect the running only an irritating light on dashboard, when i had this ( removed bumper to fit Gen 3's ) i just covered the dashboard light with a bit of insulating tape until next service when the HPC reset it.

[stu1986]

If it only needs resetting ill see if my mate can do it

[Kev T]

I think you need the consult software to do it.

[Flashgordon]

The procedure to reset Pop-Up Hood manually is:

 

1) Press twice the Start Button (Do not start the Engine, only instrumentation!)

2) wait about 7 sec, the Pop-Up light goes off ---> Press Start Button immediatly (Switch Off)

3) Press twice the Start Button (Do not start the Engine, only instrumentation!)

4) wait about 7 sec, the Pop-Up light goes off, Flashes 3 times, when goes off press Start Button immediatly (Switch Off)

5) Repeat steps 1-2-3-4

6) Press twice the Start Button (Do not start the Engine, only instrumentation!)

7) The Pop-Up light blinks slowly

8) Turn Off

 

A Link with the Nissan procedure: http://www.uprev.com... Hood Reset.png

Edited November 24, 2012 by Flashgordon

[Ebized]

Welcome to the forum Flash - great first post- thank you.

 

Be good if you could tell us a little about yourself in the intro section.

 

 

[glrnet]

The procedure to reset Pop-Up Hood manually is:

 

1) Press twice the Start Button (Do not start the Engine, only instrumentation!)

2) wait about 7 sec, the Pop-Up light goes off ---> Press Start Button immediatly (Switch Off)

3) Press twice the Start Button (Do not start the Engine, only instrumentation!)

4) wait about 7 sec, the Pop-Up light goes off, Flashes 3 times, when goes off press Start Button immediatly (Switch Off)

5) Repeat steps 1-2-3-4

6) Press twice the Start Button (Do not start the Engine, only instrumentation!)

7) The Pop-Up light blinks slowly

8) Turn Off

 

A Link with the Nissan procedure: http://www.uprev.com... Hood Reset.png

Flash I love you but we only have 14 hours to save the Earth!!!

[stu1986]

The procedure to reset Pop-Up Hood manually is:

 

1) Press twice the Start Button (Do not start the Engine, only instrumentation!)

2) wait about 7 sec, the Pop-Up light goes off ---> Press Start Button immediatly (Switch Off)

3) Press twice the Start Button (Do not start the Engine, only instrumentation!)

4) wait about 7 sec, the Pop-Up light goes off, Flashes 3 times, when goes off press Start Button immediatly (Switch Off)

5) Repeat steps 1-2-3-4

6) Press twice the Start Button (Do not start the Engine, only instrumentation!)

7) The Pop-Up light blinks slowly

8) Turn Off

 

A Link with the Nissan procedure: http://www.uprev.com... Hood Reset.png

 

thanks mate!, ill see if this works

[doctor austin]

This maybe worth putting in the guide section?

[glrnet]

This maybe worth putting in the guide section?

That's done

[Mark@Abbey m/s]

We tried it loads of times very hit or miss we have found.

 

We use a EcuTek cable to turn the light off GTR EcuTek software talks to 370z Ecu.

[rtbiscuit]

sounds like its all about the timing, same with the 350's and the fault code reding procedure.

[stu1986]

I can confirm it does work, I had to do it a few times but finally got there thanks!!!

[Ebized]

Good news

 

 

 

We tried it loads of times very hit or miss we have found.

 

We use a EcuTek cable to turn the light off GTR EcuTek software talks to 370z Ecu.

 

When you say "to turn the light off" Mark, does that mean a fault may remain, despite the reset?

[Adrian@TORQEN]

Mark tried on mine today, didn't work, need some new sensors / ecu for pop up hood, etc

[jamestan119]

On 25/11/2012 at 01:07, Flashgordon said:

The procedure to reset Pop-Up Hood manually is:

 

1) Press twice the Start Button (Do not start the Engine, only instrumentation!)

2) wait about 7 sec, the Pop-Up light goes off ---> Press Start Button immediatly (Switch Off)

3) Press twice the Start Button (Do not start the Engine, only instrumentation!)

4) wait about 7 sec, the Pop-Up light goes off, Flashes 3 times, when goes off press Start Button immediatly (Switch Off)

5) Repeat steps 1-2-3-4

6) Press twice the Start Button (Do not start the Engine, only instrumentation!)

7) The Pop-Up light blinks slowly

8) Turn Off

 

A Link with the Nissan procedure: http://www.uprev.com... Hood Reset.png

it works!!!! thanks mate!!! save back the money for mechanic. love you!