Ian

Doubt it. I fluked it first time round

Much better Please fit the N1 yourself & film it for us

Payment sent

Whats the big deal with having it factory fitted?

What about the red one that MartinMac knows of

For noise, you can't beat the ARC intake might be a bit more difficult to get now though

I wouldnt say it is as much big man talk. If someone damaged my car I would go to jail for it i'm afraid. Now you have posted on a public forum there isnt much you can do without being caught. I would have kept my mouth shut and took some serious drastic action. Its always better to target the persons family and friends rather than do it direct to him. It hurts more that way. Now its all in an open forum you're pretty much limited to what can be done and the only way to deal with it is the legal way now. Really? Youd go to jail for a piece of metal?

I paid £270 for my front bumper to be smoothed & resprayed

Thats a nogo. He sold it

I'm on my way

Could also be knocking against the W brace. I'm sure someone else had the same issue with a Japspeed, might have been Bulletmagnet?

Check at the rear by the pipes - on the drivers side there is a plastic cover that rattles against some exhausts. I had this with my Nur spec & it drove me nuts until I found it

Even upto last night I was having doubts about letting it go Done now though so no turning back (unless I decide to buy another )

Look after her for me That would be my fault with the wire, must have cut it when I was fiddling about fitting it

Bloody hell, your back You know me couldn't keep away Got another Z yet?

Won't buy a 3200, too much potential trouble with them This produces sex wee though

Which screws and clips do I need to undo, I can find screws either side of the OBDII port and one by the foot vent but apart from those 3 I'm stuck and me + guessing how to remove a panel = very happy breaker after I wreck the dash. From memory its just those 3 screws & theres 1 just to the right of the ODB port that you will see once the side panel is off. You do need to be quite rough with it to get it out though

Just remove the panel. Its only a couple of screws & it unclips