Fluke

Is there any way to remove just the cubby hole button on a preface lift car, without taking the console to pieces? My button is scratched and needs repainting, but the rest is okay.

Thanks.

Aren't the Scottish, just the Irish that could swim? Or was that the Welsh? I forget....

Thanks, let me know by PM the total and how you want paying.

No the bump stops.

I've seen it on a few cars, and have been searching for a white vinyl forum logo to go in my quarter glass. Can anyone tell me where to get one from?

Are the boot helper springs available?

Thanks for the explanation. Can you run a 245 on a 8.0 rim?

Why?

Have a look at the Appradio 2, available for £199 at Amazon.

I have a set of Rays to go on that are 8.0 all round. I plan to fit 225 all round, will that cause a problem?

No that turns a double din into a single din.

It's insured, I'm just not using it until my 5 has been sold. - it provides motivation and gives mr time to make the changes I want to make.

Has anyone used plasti dip on their centre console?

Appradio 2 for £199 on Amazon?

Stafford.

After searching for the right car in the right colour and spec, I managed to finally get the one I wanted, and I bought it fairly cheap with 49k low mileage, Berk de-cats, Miltek Exhaust, JWT pop charger, Gia Cuzzo Colour matched spoiler, front splitter and with a full service history. I only insured it for a day whilst I drove it home and its been sat on my drive while I sell my MX5. It also gives me the chance to make all the little changes I want to it, to personalise it a little. Here she is. So far I have replace the Bose radio with an all singing all dancing Appradio 2, installed a review camera and swapped over the standard boot struts with uprated ones, so that my boot lid stays up. By far the biggest change has been getting my seats reconditioned by Midlandmars, it cost me £225, but was worth every penny. The drivers seat was the worst, check out my before and after pictures. As you can see Tony at MidlandMars has done an absolutely stunning job and to be honest I was close to getting rid of them and buying a decent secondhand set, which would have no doubt set me back more than I spent getting these done, and it only took them 2 days. I have a set of Rays that I got for a bargain £300 delivered, that I plan on getting refurbed in shadow chrome. There's a new set of genuine Nissan mats on the way, along with new leather gaters to match the interior.

Thanks for the advice, I was looking at how I could add some colour or texture to the slab of black.

The actual door cards themselves.

I've been thinking about using some carbon fibre wrap on my door cards. Has anyone else done it? Can anyone that's wrapped or modified their door cards please post up a few pictures for inspiration?

I'm interested too, dependant on price. 1. Downhuman facelift/carbon 2. Arran prefacelift/carbon 3. sx Dave prefacelift/carbon 4. Hennerz prefacelift/FRP 5. Kyler prefacelift/Carbon 6. Kyte350 facelift/???? 7. Bobbyheinz facelift/ carbon 8. Squanchy pre facelift/ carbon 9. Ceejay29 Pre-facelift / Carbon 10. Payco facelift / carbon 11. s1an1de facelift/carbon 12. Mattross1313 pre-facelift/FRP 13. dan-bourne facelift/frp 14. Louisa911 pre-facelift/frp 15 StevoD pre-facelft/frp 16. FxN facelift/carbon 17. Notfub pre-facelift/carbon 18. brummiestormer facelift/both 19. Aidan pre-facelift /frp lip 20. Parsnip pre-facelift/carbon 21. Scottyd preface lift /carbon 22. MartynB85 Pre-Facelift / Carbon 23. Fluke Pre-Facelift/frp

I broke one of mine whilst fitting uprated gas struts, the lip pops open fine but, it annoys me knowing there should be 2.

I've used City Powder Coaters in Birmingham and have found there work to be spot on. The will clean/strip and power coat wheels for about £25 a corner.

Page 15 it's the po/spo mode to change your RCA settings.

Is there anything that lets you swap between sub an speakers? How many RCA outputs do you have on your head unit?