Steely Posted November 11, 2013 Posted November 11, 2013 Hi all, I am looking for a set of test pipes so I can decat my 03 zed, I still have the standard Y section installed to a cobra resonated system. I am looking for second hand set as I don't want to pay full rice for new then decide they are too loud. Does anyone know if the O2 sensor is alarmed can you reset with the torque OBD2 software on Android? Cheers, David 1 Quote
Ekona Posted November 11, 2013 Posted November 11, 2013 Without O2 extenders, built-in or screw-in, you will be setting the CEL off. Yes you can reset it, but would you really want to do that every single time you drive? O2 extenders are a must have with decats. Quote
aidan Posted November 11, 2013 Posted November 11, 2013 Even with extenders....it still might throw up fault. Some do, some dont' . Mine does Can easily be reset /checked with OBD thingy. I'll probably change back to cats at next MOT. Oh and they are loud...but how loud depends on rest of exhaust. mines mated to Milltek so probably on the "quieter" side. Quote
Ewen@Clark Motorsport Posted November 11, 2013 Posted November 11, 2013 We sell the spacers for £12 each should you need them http://www.clarkmotorsport.co.uk/parts/Oxygen-Sensor-Spacer/113041 Quote
Steely Posted November 12, 2013 Author Posted November 12, 2013 How does the spacer work, it looks like the spacer would take the sensor probe further away from the exhaust flow? Its not sounding like the best idea to decat by the sounds of it. Thanks for your help. Quote
DoogyRev Posted November 12, 2013 Posted November 12, 2013 How does the spacer work, it looks like the spacer would take the sensor probe further away from the exhaust flow? Its not sounding like the best idea to decat by the sounds of it. Thanks for your help. Correct If you decat you will need to swap them for the originals every time you have an MOT ... Unless you know a very friendly tester. Most people go for HI-flow cats which will pass MOT's and give a nice note to your exhaust tune . Although you may also need the spacers on hi-flows unless you get a remap. PM one of the traders for details. Quote
SamN Posted November 12, 2013 Posted November 12, 2013 The secondary O2 sensors on the cats are only to tell the engine whether the cats are working or not as far as I'm aware. One or both of mine are knackered and the car runs fine! I fitted decats and haven't sorted the O2 sensor and it still runs fine Quote
Steely Posted November 13, 2013 Author Posted November 13, 2013 The secondary O2 sensors on the cats are only to tell the engine whether the cats are working or not as far as I'm aware. One or both of mine are knackered and the car runs fine! I fitted decats and haven't sorted the O2 sensor and it still runs fine I didn't realize the zeds had two sets of 02 sensors, I just assumed it used this to adjust engine timing for emissions, if you remap does the engineer just disable the secondary 02 sensors then? Quote
Dblock Posted November 13, 2013 Posted November 13, 2013 The secondary O2 sensors on the cats are only to tell the engine whether the cats are working or not as far as I'm aware. One or both of mine are knackered and the car runs fine! I fitted decats and haven't sorted the O2 sensor and it still runs fine I didn't realize the zeds had two sets of 02 sensors, I just assumed it used this to adjust engine timing for emissions, if you remap does the engineer just disable the secondary 02 sensors then? Yep . Secondary ones are purely to check cat efficiency. Quote
Mctwist Posted November 14, 2013 Posted November 14, 2013 I have a nice looking 2nd hand set, with some fresh gaskets. How much are you looking to spend Sir? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.