Jump to content

Stillen gen 3 engine light ?


Kharmon

Recommended Posts

Hi guys just installed the stillen gen 3 intake. booked it for a tune on the 21st .The only problem is my check engine light is on any idea why ? The car seems to be driving fine . Could the maf sensors need cleaning ? If so what do i clean them with ? Thanks in advance

Link to comment
Share on other sites

And now you have no idea what the code was, could've been something important. Why did you not just get it read?!

I have to agree with Dan you would have been much better checking the code Op just to be certain as to why it came on.

 

I mean if you knew for example it was caused by a secondary O2 sensor fault after fitting HFC's or De-Cats then by all means reset the ECU and wipe the code but without knowing is a little haphazard.

 

Hopefully it was nothing serious. Definitely worth following sipar69's suggestion imo. :thumbs:

  • Like 1
Link to comment
Share on other sites

I read on the american forum that it happens if you dont disconnect the battery during the install which i never .so dont worry the ecu just needed resetting. Will have a look in to getting one of them wifi dongles though sounds handy to have thanksðŸ‘

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...