hairyman68

Hi looking for a pair of spacers for the sensors on my 05 plate 350....? Any ideas... Cheers

Has anyone bought a carbon bonnet with vents in it..? Fancy one but worried about water getting in through the vents.....?

Ok I'll give it a go.. I'm using an iPad and not great on Computers... Sorry.

http://s908.photobucket.com

No problems with mine...

I've got this at the moment... Tried various sprays but won't settle.. It's been adjusted twice... Worst if you start and load the alternator up Ie opening the roof...then it stops....ggrr

Hi anyone fit these during the winter..? If so what are people fitting..? Saw some Toyos but only come in 225x45x18 but not the 245 for the rear... Or just use 4 the same size..?

Hi daft question, but do I have remove the front bumper to swap the side light bulbs out..? Cheers.

Did you remove the sill plates to wrap them..? If so do the just pull off..?

Looks fab, can I ask how much..?

Saw a 350 like mine this morning.... On the A1231 from Washington (Sunderland). 7:45am..... Shot off into Sunderland.

Bought just a few mths ago. Still struggling to post pictures as on a tablet rather than a PC. It fairly straightforward.... There's a long series of how to do it on u tube. But it you go step by step it's ok. Removed and fitted new in under 7hrs....

This is where I ordered mine from.... But fitted it myself...

That's great guys, thanks for all your input....

Hi looking to sell my GSXR but but unsure about best practice of organising a test drive...other than seeing a full bike license and £3000 cash..? Any ideas please..? Thanks.

Hi would you take 40 for them. Only in Sunderland so can collect...

You can do it yourself. I did it in just a day.... There's a video on u tube to walk you through it....

PM sent

Can I ask much it was. Is it difficult to fit ..? How do you disarm the airbags..?

Yes done. Have mounted up by the mirror and as I've a Roadster I managed to slip under the trim and rubber bits and up under the bits in the footwell.

Grumpy, I bought Alpine as listed above. Sure there 6.5" . The link is just a small piece of cable (speaker type twin). It runs from the speaker itself and out of the old cable plug (removed so you can thread the link through it) and then connect to the original cables. ...? That make anymore sense..?

Welcome from Sunderland. Happy hunting...

It's a Roadster.

Gumpy, just lifted the speaker grill off to allow access and pulled the bottom of the door off the little plastic clips. Then 3 screws , 2 off which you can unscrew with a screwdriver and the lower one I used a 10mm ratchet as the screws have a hex head 10mm. Then disconnect the white cable clip on top and carefully pass the speaker between the door frame and door skin, ie out the bottom of the door. I cut the old ones out with cable cutters to leave just the out frame. Remove the white cable mount. The new speaker then mounted onto the ring with just 3 screws. Then make a short cable link up to allow you to attach to the speaker and then cable out of the hole in the top of the frame (where the white bit was). You can then re mount the speaker the same way it came out and use the link wire and 2 bullet connectors to reconnect the speaker. No have not upgraded the cable. Can see no need . Sounds great as is. New pioneer head unit going into tomorrow. But not sure how to access the rears for their upgrade. Hope that makes some sense. If not message me for any help....

Just upgraded my front speaker to Alpine SPG 17C2. Wow much better sound now. My question is how easy is it to access the rears on my Roadster..? Are they the same size ..? Could use same speaker..? Cheers.