Fluke

Can anyone tell me if the dash centre console from a 2007 facelift 350z will fit the earlier 2003 350z? I will be using an aftermarket radio so that should not be an issue.

Should be here tomorrow.

Thanks, nuts and bolts ordered.

My Ark Grip exhaust and Cobra HFC's are arriving on Friday. I plan on getting them fitted by a National Tyres and Autocare as they are local to where I live and would be able to do it this Saturday. Is there any tips or pointers I should look out for, or should it be a straight forward job on a 2003 350z?

Great guide. Can the heat gun be used on FRP?

Would the one pictured be able to be levered down with a bit of wd40 to help it? I'm at work at the moment and need to drive the car home.

Just looked under my car and its now barely on. How easy is it to replace the completed arm?

How easy is it to replace the Banana arm bushes? I've done loads of suspension work on my cars in the past, but have never had to replace bushes. Is it a DIY job with a 6 tonne press and a few sockets?

A hydroshield AKA hydro sock is a waterproof/resistant "shield" which goes over an air filter to prevent water from being drawn through the filter whilst still allowing air to be drawn through. Thanks. That looks like it would hinder air going into the filter.

Hydroshield?

Engine bay bling and noise. I've read that a few extra bhp from the velocity stack mod wont make a noticeable difference. I thought that getting a CAI system would be the best of both worlds, cooler air getting into the engine and a bit of roar under load. I will be ordering Cobra HFC's and an Ark system come payday on Wednesday, especially as its also my Birthday.

I want to swap out my air box on my 2003 350z. I had a look at the pop chargers and they seem ideal apart from sucking in hot air as the engine bay warms up, so now I find myself drawn to CAI like the Injen or the AEM. Does anyone have either one fitted and would like to share their thoughts on CAI?

Thanks. I have now had it checked by the local Halfrauds and they say I have a leak somewhere. I did notice it was a little damp on the floor under the front passenger side when I went to take it round to them this morning.

Last night I got caught in really slow moving traffic and noticed that my windows started to steam up rapidly. I had the air conditioning on cold and was getting warm moist air blowing through. As soon as I was out of the traffic jam and picked up a little speed the air conditioning began blowing cold again. I had the same issue again this morning when I sat parked for a few minutes. I haven't had time to investigate fully, but am thinking that it might be the air con fan? Any one else had the same problem or would like to give me an idea what might be up?

Anymore left?

what rear is that.

I like that front bumper. What's it called and does it have DRL's fitted?

Are they any better than the Berk's when it comes to MOT time?

I can't see the Cobra HFC's on your website, have you stopped selling them? Are the more likely to pass an MOT emissions test?

Any problems passing an MOT with the Cobra HFC's?

I am going to have an Ark Grip fitted and was thinking of fitting either Berk Or Cobra HFC's. Apart from the price what's the difference in sound etc..?

I swapped out my clockspring to try and fix a problem with my cruise control not working. Unfortunately I now have my VDC off and my slip light on. Is there anyone near Birmingham or Stafford that could reset my steering wheel angle sensor? Obviously I would be willing to pay.

I like the look of that. I have a charge speed bumper waiting to go on. Have you done anything with the front end?

Can anyone tell me if the Consult III Plus software needs a specific piece of hardware to allow it to be used on a lap top, or will an ODB2 reader hooked up via usb work?

I am still torn between the Nvidia and the Ark Grip, but am edging towards the Ark system. From photos' I have seen, they look as if they hang very low. Does anyone that has the Ark Grip fitted suffer from them scraping on speed bumps etc..?