Fitting Berk HFC's any advice?

[martek]

Hi Guy's

I'm going to have a go at fitting the Berk HFC's, had al ook under the car and they look a bit of a bugger to get to the top manifold bolts, so any advice welcome.

Cheers Dave.

[buster]

make sure you have lots of extension bars for the socket set.spray wd 40 on the night before and get yourself some spare exhaust bolts/nuts.

[ioneabee]

my advice - get someone else to do it

 

its a bitch

[Neilp]

my advice - get someone else to do it

 

its a bitch

 

I agree!

[Arran]

Its not that hard! One nut needs an extension from the engine bay then the other two from under the car

 

obviously there are a pair

[scobie140]

Better with plus gas rather than than wd40 but will still be a pain to get them off

[K370Z2]

Keep advice coming on ways to do it urself cause i have a set to fit my self Ha Ha

[BillyZed]

Plus gas is the best thing since sliced bread

[ioneabee]

seriously - have a garage on standbye

[Neilp]

The nuts will be seized solid and will probably snap.

[martek]

Is it a problem if they do snap, the Berks all use nuts and bolts?

[MITZ@CougarStore]

If they snap they'll probably need drilling out...

[jumping350]

Or pop it to a garage and get them to crack nuts for you and bung them a tenner, take home and swap, if they snap a stud/nut you might as well get them to finish job