jerry3167 Posted September 30, 2009 Posted September 30, 2009 Hey Guys, How do the Z side badges come off? Are they glued down or clips/ bolts etc? I have some new Z badges for the wings... Cheers Jerry Quote
Ian Posted September 30, 2009 Posted September 30, 2009 clips I used a very small flat blade to start them off Quote
jerry3167 Posted September 30, 2009 Author Posted September 30, 2009 clips I used a very small flat blade to start them off Cool, so the screwdriver goes under the whole badge that is in contact with the wing? Quote
rtbiscuit Posted September 30, 2009 Posted September 30, 2009 heat gun to get you started, use a knife to lift the edge enough to get your fingers under, and then prise with fingers, don't use the knife for the whol ejob, as you run a high risk of slipping and scratching paint work. and its held on with very strong adhesive foam tape and 2 pins that fit into locating holes. Quote
sketch Posted September 30, 2009 Posted September 30, 2009 do they all come with the Z badges as standard? not sure i like them Quote
jerry3167 Posted September 30, 2009 Author Posted September 30, 2009 do they all come with the Z badges as standard? not sure i like them Of course they come as standard Quote
BladesGrant Posted September 30, 2009 Posted September 30, 2009 I was messing under the arches when I removed mine so pushed them out from the back by taking the rear arch liner off from the front wheel. I also had to wire mine up as have the LED badges so it was easier for me to do that. Only the adhesive holding mine on, the pins are just for locating it in the right place from what I could see. Quote
rtbiscuit Posted September 30, 2009 Posted September 30, 2009 the pin are just for location, and so you can't put them on upside down Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.