Jump to content

All Activity

This stream auto-updates

  1. Past hour
  2. ZMANALEX
    Sunday Bump
  3. ZMANALEX
    Sunday Bump
  4. ZMANALEX
    Price drop to £30.00
  5. ZMANALEX
    Sunday Bump
  6. ZMANALEX
    Sunday Bump
  7. ZMANALEX
    Sunday Bump
  8. ZMANALEX
    Price drop to £40.00
  9. ZMANALEX
    6 in stock
  10. ZMANALEX
    Sunday Bump
  11. ZMANALEX
    Sunday Bump
  12. ZMANALEX
    Price drop to £400.00
  13. ZMANALEX
    2 in stock
  14. ZMANALEX
    6 in stock
  15. ZMANALEX
    4 in stock
  16. ZMANALEX
    2 in stock
  17. ZMANALEX
    4 in stock
  18. ZMANALEX
    6 preowned in stock
  19. ZMANALEX
    30 in stock
  20. ZMANALEX
    4 x sets in stock.
  21. ZMANALEX
    Sold List updated 08/06/2025. Still some parts available.
  22. Yesterday
  23. muzzer started following Wiper Blades
  24. muzzer

    Wiper Blades

    muzzer replied to Taff's topic in 370z General

    Will the Bosch SP20 be ok on the rear? Used one of a two pack on the front, can’t find info about the rear spec anywhere. Thanks as ever.
  25. Wolf24h
    Didn't want to start a new thread so I'll revive this one. I'm looking for the closest match touch up paint pen to use on the stock sport wheels. Can't find any using the Rays paint code, anyone found some alternative?
  26. mr v6
    Have you scanned it for any codes, pending in particular? I've had coils that were starting to go & were affecting drivability but hadn't put the EML on. I've had coils that have turned the EML on. I also found a throttle body clean & perform all the resets on here helped with my idle issue too.
  27. Willbof

    GK Tech

    Willbof posted a topic in Suspension

    Just got round to kicking up my GK Tech lock kit and came across a few concerns. V3 lock kit Rack spacers Inner tie rods. It would appear that I have considerable lock improvements so that is great. I took my time trimming the inner rods to get maximum engagement, probably cut them 3 times each until I am reasonably happy. Now the issues, on full lock the 'heim' joint is now the bump stop as it contacts the lower shock bolt. I have removed the OEM bump stops but I think with a small trim it would probably be wise to reinstall these. On the opposite side the Hel brake line comes quite close to contacting the shock due to the enormous 90 degree fitting they came with. I also noticed that the spacers aren't being utilised at full lock as the joint/bolt interference stops the rack moving any further. Anybody have any experience with this kit? My suspicion is that I need the lower arms to utilise all the other mods which I'm a bit upset about as I've already spent too much!
  28. ShortPaul
    Ok🤣 remember Captain and Pimm's are they still around on here?
  1. Load more activity
×
×
  • Create New...