Darren350 Posted March 6, 2014 Posted March 6, 2014 (edited) Guys, how do i remove the two window panels? Pictured as below: Sent from my GT-I9300 using Tapatalk Edited March 6, 2014 by Darren350 Quote
AliveBoy Posted March 6, 2014 Posted March 6, 2014 get something metal under it and gently pry it off, it's held on with poppers I believe. Just be careful as its easy to break Quote
ZEUS Posted March 6, 2014 Posted March 6, 2014 Warm it up with a hair dryer first then the lugs won't snap off Quote
Randy_Baton Posted March 6, 2014 Posted March 6, 2014 its called a 'b-pillar'. That should help you find instructions. Its the first thing I wrapped, remember to peel off the two rubber edges before wrapping and glue them back on after. I think I had to cut mine off. Quote
Darren350 Posted March 6, 2014 Author Posted March 6, 2014 Off now guys! Thanks! Randy I've removed them to wrap them and was planning on wrapping the rubber seals as well. Is this not adviseable? And would it hurt just removing them completely? Do they serve much of a purpose? Sent from my GT-I9300 using Tapatalk Quote
Randy_Baton Posted March 11, 2014 Posted March 11, 2014 I think they stop water getting in behind the b-pillar, I just glued mine back on with super glue. Apply a hair dryer to them and they should come off pretty easily. I also clear coated my wrap to make the carbon look a bit shiny. I wrapped a ruler and laid down masking tape a regular intervals to see how many layers of clear coat was best, think I went for 3. Quote
ATTAK Z Posted March 11, 2014 Posted March 11, 2014 Off now guys! Thanks! Randy I've removed them to wrap them and was planning on wrapping the rubber seals as well. Is this not adviseable? And would it hurt just removing them completely? Do they serve much of a purpose? Sent from my GT-I9300 using Tapatalk Removing them completely is a definite no no ... I'd polish them up or get them sprayed Quote
ATTAK Z Posted March 11, 2014 Posted March 11, 2014 Off now guys! Thanks! Randy I've removed them to wrap them and was planning on wrapping the rubber seals as well. Is this not adviseable? And would it hurt just removing them completely? Do they serve much of a purpose? Sent from my GT-I9300 using Tapatalk Removing them completely is a definite no no ... I'd polish them up or get them sprayed mine after polishing Quote
leonk Posted March 11, 2014 Posted March 11, 2014 I wrapped mine and if you are very careful you can tuck the wrap behind the rubber. Trim it off with scissors leaving about 3mm excess and then tuck it behind with a plastic spreader or similar. Quote
Darren350 Posted March 11, 2014 Author Posted March 11, 2014 Thanks for the advice guys! I removed and wrapped them including the rubber seals. Here is a snap: Sent from my GT-I9300 using Tapatalk Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.