Help with measurement

[Keyser]

Hi all, I need some help please, When I stripped the old 350z I took loads of measurements so I could build my Ford Pop using the rear suspension but I forgot one

 

From the top of the rear spring hanger, it sticks out about a cm from the inner wing -

 

This thing

 

 

Yours will still be attached

 

To the shock absorber mounting point here

 

 

So from the top of the plate in pic 1 to the bottom of the shock - the red line in pic 2. can anyone put a tape measure against one and let me know how far it is please.

 

Thanks Guys n Gals

 

Keyser

Edited October 27, 2018 by Keyser

[Keyser]

bump

[RobPhoboS]

Hello mate, I can definitely do this on the weekend if you don't mind waiting a little bit ?
I'm updating my suspension, so it'll be easy peasy.

[Keyser]

2 minutes ago, RobPhoboS said:

Hello mate, I can definitely do this on the weekend if you don't mind waiting a little bit ?
I'm updating my suspension, so it'll be easy peasy.

That would be awesome if you could please

I think I can wait until the weekend I doubt I'll be even close to needing by then - I just forgot to take that one measurement

 

Thanks

 

[RobPhoboS]

I'm just under the car now... 

So the spring plate is over the spring of course but I'm slightly confused as to what you want measured exactly. It's over the spring bucket not the shock. 

I'm probably reading it wrong! 

[ZMANALEX]

 

I'm with you Rob:    

[Keyser]

Just got back in - A picture should help

 

 

Distance between the 2 red lines so top of spring carrier to shock mount

 

Thanks

[RobPhoboS]

Ahhhh ok.
I'll be under it again later in the week, so no problem !