mr2rivers

I know these parts have been mentioned by other users but in case they have not taken them for what ever reason, could I please have the drivers side window motor and the drivers side exterior window trim? Thanks.

ZMANALEX. I have been trying to send you a PM. Apparently you cannot receive new messages. I wanted to talk about purchasing some parts from you.

Welding is not an issue. I can weld the flanges on later. PM sent.

I would be interested in the back box. What condition are the pipes? Could they be polished up nicely?

Would you consider posting the springs to Oxford, England?

Thanks harryjackson for clearing that up. I didn't think it was a 'W' brace.

How much for just the spacers? Or what did you have in mind for a swap?

Hi there, Is this from the 350? if so which year? Mine looks considerably different. Obviously the rust doesn't help...

Yeh, I have just found them on ebay and they are cheaper on there than even the 10% would give you from the website. Think I'll just buy them on ebay.

Is this still an active discount? If so can I please have a discount code? Thanks in advance.

Cheers GMballistic. That is the ticket, exactly what I was looking for. ZZZebady, I thought someone on here would have already done what I was trying to do. Good work. I have treated all the bad bits (i.e. wire brushing... Hammerite rust care... wire brushing... black Hammerite under seal - containing wax oil). I was just concerned with the 'W brace' as it basically fell to bits while I had it off the car trying to clean it up. Yours is in far better nick than mine - If you look at the picture I posted of the 'W brace' you will see I have next to none of the strengthening bits left on the arms (see where the circles are on yours).

Here is a picture of my Zed. Sorry it was the day before 'wash day' haha

Hi all, I am a newb and owned my Zed for only a little over a month. I was checking the underneath of the car the other day because I want to get a custom built exhaust on there at some point soon (probably when my bank balance recovers after my holiday in September) and I wanted to check to see if they would have any problems removing the old one. Well it turns out they will there is quite a lot of rust on the under side of the car. The exhaust bolts are pretty bad, but I am sure they will be able to deal with it. Most parts other than the exhaust were not too bad and I was able to clean some of it up and treat it properly before giving it a coat of Waxoyl. A coupe of the smaller bolts sheared on me (not good), luckily they were only holding on a could of plastic guards and I will sort that out soon. The one bit that stood out from the rest was the rear chassis tie bar (pictured below hopefully). This was heavily rusted, so I took it off the car to photograph it and attempt to clean it up and finally under seal it. While trying to clean it up I found that the poor design had meant it was able to store wet mud for years and it was virtually useless and peices of metal were just falling off in my hands. Has any one else had any experience with this and does anyone know where I can pick up an after market version or even just an OEM replacement? I have searched eBay but I don't really know what its called and I haven't been able to find anything. Thanks in advance for the help. I will set up a photo bucket account shortly and get some pics up of the Zed for all those interested.

I'll take it. When was the last time you had it working? Send me a PM with your Paypal address and I will send the money. Sent from my iPhone using Tapatalk

Is the Bluetooth module still available? how much do you want for it?