Jump to content

Jonnymonno

Members
  • Content Count

    716
  • Joined

  • Last visited

Everything posted by Jonnymonno

  1. A friend did it for me, let me know if you want yours coating
  2. Finally got around to buying the Stillen engine cover, hides the exposed wiring and pipes. also the Nismo oil filler cap both from Torqen
  3. The company i use will powder coat virtually anything so let me know
  4. Got the strut brace plastic coated at long last to finish the look in the engine bay
  5. Can’t believe how bad that original W brace has gone, I think you caught it just in time keep up the good work
  6. In the US they don’t have to have a front plate but I think it looks ok where it’s mounted on mine
  7. Here you go, once the bumper is fitted you can remove the tray in front of the radiator and get access to the back of the bumper to fit two number plate bolts There is a small section just below the air intake where you can mount the plate but not enough to hold the plate on with double sided tape.
  8. Wayhaay Teejay Just caught up on your build thread, looking good mate Call for a brew when you're passing
  9. Probably the best mod iv'e made
  10. I had this issue on my 370 with the Torqen coilovers and it was the diameter of the bolt is a few thou smaller than the diameter of the hole in the bottom of the coilovers,so no matter how tight you tighten it up it stays loose. As a temporary fix I wrapped shim steel around the bolt to test it and the clunk went away This will definitely be your problem if the 350 is the same Good luck

350z-uk.com

370z-uk.com

350z-uk.com

370z-uk.com

×
×
  • Create New...