bpmjames

What diffuser is that? Sent from my C6603 using Tapatalk

That's kinda what I meant. The video shows the process but I didn't know how the sheet actually adhered to the surface. Like wether it was a chemical reaction or it literally just stuck to the surface Sent from my C6603 using Tapatalk

Thanks for the replies but how does it work? Sent from my C6603 using Tapatalk

I've just been looking at this on YouTube and it looks great. I think a few guys on here have 'dipped' interior bits? What's the actual process of it or rather, how does it work? Any ideas? Jim Sent from my C6603 using Tapatalk

I found with mine that I had to swap the two colours around for the signal to and from the module then the switch worked the right way. I have to leave my switch in the normal unfolded position and it works fine. Also I dumped the scotch locks as they didn't really work for me. They weren't strong enough to cut the insulation on the car side cables Sent from my C6603 using Tapatalk

That looks like the right purple wire to me Sent from my C6603 using Tapatalk 2

I'll take the clear ones mate Sent from my C6603 using Tapatalk 2

Haha fair point and duly noted mate. It's easier to reach too. Might just do that Sent from my C6603 using Tapatalk 2

U have pm mate. Sent from my C6603 using Tapatalk 2

Galaxy tab 2 mate Sent from my C6603 using Tapatalk 2

I've get a k2 of your interested Sent from my C6603 using Tapatalk 2

Here's a couple of better pictures of the final install I think I'm going to redo the trims at some point or make a fibreglass one. Sent from my C6603 using Tapatalk 2

Got a link mate I'm after one too Sent from my C6603 using Tapatalk 2

I'm going to finish it tomborrow so I will do some tomorrow afternoon for u Sent from my C6603 using Tapatalk 2

Nope I'm using the tablets speakers and the tablets GPS both are more than adequate Sent from my C6603 using Tapatalk 2

Still not mounted fully but running TomTom 1.3 and working really well Sent from my C6603 using Tapatalk 2

Style 95, from a 7 series (E65/66/68.) What Sam said :-) Sent from my C6603 using Tapatalk 2

Looks like it works with the Galaxy note 2 also Certainly does :-) Sent from my C6603 using Tapatalk 2

Thanks a lot for this guide Ads. It's helped me get my galaxy note 2mounted in the car. Here's a couple of pics, just need to sort out the trim round the edges. I used a push to make button and mounted it next to the seat switches. I also managed to use the oem latch for the cubby with a bit of trimming. Sent from my C6603 using Tapatalk 2

Got it working in the end. The scotch locks weren't strong enough to break the insulation on the cables Sent from my C6603 using Tapatalk 2

Right Iv just got all mine wired up including the blue wire attached to the purple wire behind speaker. The relay clicks when I use the switch to foldunfold mirrors but on lock and unlock it does nothing? Sent from my C6603 using Tapatalk 2

Today at the bp garage then a bit down the m1, i was in my azure Sent from my GT-N8010 using Tapatalk HD

I had to use a hammer and chisel on mine, it took me around 3 hours to get it free. The stud is pretty strong so dont worry too much about snapping it off

I didn't have the map done someone else did but I think it was at Abbey. The revs arent restricted. It's a fault with the cruise control circuit Sent from my C6603 using Tapatalk 2

How much do u want for the rear bumper? Sent from my GT-N8010 using Tapatalk HD