djtimo Posted May 7, 2015 Posted May 7, 2015 Looking for a way to remove the airbag and seat belt lights the dash ? My car has harness and no air bags once the new steering wheel is in so all a bit point less. Thanks Quote
flyboy Posted May 7, 2015 Posted May 7, 2015 Won't pass an MOT but it can be done by removing the LED at board level. No passenger airbag or side impact bags either? Quote
djtimo Posted May 7, 2015 Author Posted May 7, 2015 Won't pass an MOT but it can be done by removing the LED at board level. No passenger airbag or side impact bags either? Not to worried about MOT if you get me. No seat/curtain/pax/ or wheel air bags anymore. So dash light just flashes away annoyingly lol.. Remove LED at Board level? Is that an easy job or dash out etc? Quote
AliveBoy Posted May 7, 2015 Posted May 7, 2015 Just put a resistor into the circuit, 2.2ohm I believe, then all the other airbags still work Quote
djtimo Posted May 7, 2015 Author Posted May 7, 2015 Just put a resistor into the circuit, 2.2ohm I believe, then all the other airbags still work LOL., what airbags Quote
flyboy Posted May 7, 2015 Posted May 7, 2015 Won't pass an MOT but it can be done by removing the LED at board level. No passenger airbag or side impact bags either? Not to worried about MOT if you get me. No seat/curtain/pax/ or wheel air bags anymore. So dash light just flashes away annoyingly lol.. Remove LED at Board level? Is that an easy job or dash out etc? Dash out, clocks dismantled. needles removed. pcb board exposed, led unsoldered or flicked off, Needles re attached and re calibrated while vehicle moving, re assemble clocks, re install dashboard. About 2 hours if you have taken it apart before about 3 to 4 if you havent. Look for gaugecraft website where they change the led colours in the dash for instructions on how to do it all. Quote
Keyser Posted May 7, 2015 Posted May 7, 2015 OK Put a lot of resistors in AFAIK the seat belt switch is a straight bypass or if you have the clips still in just get one of the ends from eBay or cut the ends of your old belts and plug em in. Quote
AliveBoy Posted May 8, 2015 Posted May 8, 2015 Or just cover LED with a bit of black tape lol This! EML, Airbag light for me Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.