urgent help needed lower control arm

[rodgeevans]

 

Currently under the car trying to replace the arm all nuts removed but still cant get the arm off its stuck on this bolt any suggestions please or am i missing something

 

 

[ZMANALEX]

They can be tight, so use plenty WD40 or similar and get a spade chisel in between the top of the arm and the chassis to break the seal.

 

Never had to cut one off yet and I have removed dozens.

 

Alex.

[rodgeevans]

Thanks Alex I been soaking it in wd40 and tried prying it off and it not budged an inch will give it another soaking and try again loosing the will with it.

[GMballistic]

When you pry it again try giving it a tap with a rubber/nylon mallet at the same time to see if it shocks it a bit to start it moving off. .

 

Oh and by "tap" I mean put some muscle into it.

[ZMANALEX]

Thanks Alex I been soaking it in wd40 and tried prying it off and it not budged an inch will give it another soaking and try again loosing the will with it.

As per my previous post, a spade chisel and a big hammer will break the seal and then you will just have to work away at it working the bushing sleeve down the chassis stud.

[rodgeevans]

Thanks guys unfortunately ran out of daylight without getting it moving but will pray for better luck tomorrow got mot at 4 so hope it goes better tomorrow got the spade chisel ready and a blow torch and angle grinder as last resort