Xtreme SMF & Twin Plate Clutch Problem

[.:Bullen:.]

Hi guys just fitted the Xtreme twin plate clutch & solid flywheel. All went ok and bolted back together however the clutch pedal travel is now really high when biting and when it does bite it sounds as though its perhaps catching or sliping ?

 

Any ideas on how to sort it ive googled and read about adjusting the clutch pedal travel which i did wind out 2 turns but not sure that helped ha

 

Thanks in advance

[ZMANALEX]

Best to go back to the supplier and ask there advice and recommendations.

 

If it is a Forum Trader, then I am sure that they will be more than happy to help you out with your issue.

[.:Bullen:.]

Yeah it was Clark Motorsport I have pinged them a email to see if they have any advice

 

 

Sent from my iPhone using Tapatalk

[ZMANALEX]

Yeah it was Clark Motorsport I have pinged them a email to see if they have any advice

 

 

Sent from my iPhone using Tapatalk

 

I am sure that Ewen will respond as soon as he picks up your email.

 

Not sure what he is up to today but should be back in the office Monday morning.

[Adam B]

When mine was fitted the problem was opposite, bite point right on the floor. Adjustment of the pedal cured mine

Edited September 7, 2016 by Adam B

[Swiftyy]

Interested in the outcome of this as I was going purchase the same kit at the end of the month for my 50..

[.:Bullen:.]

It turns out was just the noise from the solid flywheel, once the revs rise it's not an issue. I did adjust the pedal but done it too low so I need to raise that back up again but other then that happy with the clutch kit so far

 

 

Sent from my iPhone using Tapatalk