Jump to content

mr v6

Members
  • Posts

    541
  • Joined

  • Last visited

Posts posted by mr v6

  1. I can just manage to get to them from the top. Using ratchet spanners help a lot. Remember that as the bolt is upside down, you'll loosen the way you'd normally tighten, if you go from above. Just don't forget to loosen the bolt in the centre of each pulley first, IIRC they're 12 or 14mm.

    • Like 1
  2. Maybe if you can find a decent used branded one on ebay (if you were to go down that route), then take it & your Z to an exhaust place for them to fit, plus you'll get the choice of many tips, so you'll be able to get as close to OEM as possible:thumbs:.

    • Thanks 1
  3. Without stating the obvious, you sound more than capable of doing this job, but could it just be a case of the piece of hose you're using isn't 100% tight around the nipple causing a tiny bit of air to enter the hose where you've pushed it on, making it look like air is in the system?

  4. As you were going sideways, there's a very good chance you've damaged a suspension or steering component. Sounds like they've just performed an alignment as that's what you asked them to do. Inspection should have been mentioned & checked beforehand.

    • Like 1
  5. Ewen, I received a message last week from you about this error on your site. I have messaged you since but haven't had a reply, the phone number is just ringing out. Not sure if you're closed for business.

     

    Can you please get in touch.

     

    Cheers:D

×
×
  • Create New...