mrchic

Hi all Recently ordered the below for my Gun metal Zed, thought it may help people who are looking for such a kit. Have heard good reviews on here and postage is free http://www.ebay.co.u...2-/221134327165 Paint Code is WV2

Pulled directly from the official Nissan Service Manual. So if it does not work for you, then there may be a problem with your airbag system and it should be checked out. 1. Turn ignition switch from OFF to ON. 2. Air Bag warning lamp is on for 7 seconds and turns off, the turn ignition switch OFF within 1 second after the lamp turn off. 3. After ignition switch is turned OFF, wait for more than 3 seconds. 4. Repeat steps 1 to 3 two more times. (Perform 3 times in total.) 5. Turn Ignition switch ON. 6. The SRS lamp has been reset. Is this the general reset guide Cheers

Thanks guys Seems common then, can you advise on the reset bit please It doesn't help that the light gives no indication of what's actually wrong, like when the door sensor light was flashing and spent ages shutting the doors, until i realised it was the boot that was not closed properly

Hi all When i purchased my Zed, the Airbag light was flashing, i had my local garage perform a diagnostic check and they managed to stop the light flashing. Below is the notes from the technician following the work. "Carried out diagnostic checks into the air bag found fault code for O/S/F Side air bag (error not present) carried out wiggle test to harness, still not fault shown, refitted multi plug back to seat, cleared codes, the light is now off, customer to monitor." I had the work done in December last year, so its about three months with the light not flashing. Any advice on a way forward, does the notes above sound like it was just a case of refitting the plug, i had a quick look/feel under the front seat for cables and it didn't seem like i would be able to refit any plugs easily without lifting the seat slightly. can someone explain the error not present part, and does clearing the code stop the light flashing, Thanks all

Would the Plastidip spray version be suitable for touching up a scrape on the front bumper, caused i think by going down a kerb from the drive. Was thinking of a touch up pen kit as they normally have some filler included. the scrape is about an inch. i want to remove the front bumper anyway, and might be easier to paint when off car and inside http://www.plastidip...ey&pid=PLD-0156

I buy this, as you get 200g, you can cut into about 6 slices. so it will last. http://www.ebay.co.uk/itm/BILT-HAMBER-Auto-Clay-Bar-200g-REGULAR-/110908447282?pt=UK_Car_Accessories_Car_Care_Cleaning&hash=item19d2a89a32 This is there proper website, but you have to pay postage i believe http://www.bilthamber.com/clay-bars Designed to be used with water as lube, but i sometimes use a bit of dodo juice lube As Wasso pointed out, lightly glide the clay across the paint, you will feel when its hitting grime, and you will feel when its been removed as well. If the paint feels really rough along the bottom of doors and wings, i normally use something like TRIX which is Iron X and Tar X combo for removing Iron deposits and Tar. I use on wheels too. Smelly stuff though and needs rinsing off well

Hi all All well so far with trips out today, Clutch sensor/connections seems the way forward on investigations Some googling suggests clutch sensor adjustment/replacement may fix if this is the problem

I never got one with the car unfortunately, was the first thing i asked when i bought it Thanks

Hi Guys Thanks everyone for the quick replies very late last night. I tried the car and nothing so left it parked overnight as i was at my Girlfriends so no major panic. Started this morning no problems as if there was never a problem, so seems battery is fine?, got home turned off, turned on fine, went to work for a few hours, came back all fine. no slow cranking or anything like that I'm wondering about the immobiliser as someone already pointed out, or is the security system kicking in and stopping me starting. I will just have to see, and just one of those things. What i did do last night was get out lock car, walk round unlock and open passenger door, lock unlock then tried and it worked? Anyway on a plus side the woman cashier in the petrol station said is that your beautiful sports car as i paid, before then being stuck there ten minutes My first compliment. Thanks again, and ill keep you posted

Uk model Battery seems gauge reports ok Going to try starting soon Thanks

Hi all Been having trouble starting the zed, started a few days ago clutch down turning key but nothing. Normally key out and trying again has fixed. Happened tonight and coudnt start for ten minutes, locked and unlocked doors a few times then it worked. But getting worried now it keeps happening Any Ideas Alarm playing up maybe Thanks

Hi Mate , i bought these today,£39.99 http://www.ebay.co.u...984.m1497.l2648 I drove last night just after the snow was settling, it was awful

Thanks for replies everyone. That kit looks fine Cheers

Morning all Can anyone recommend a set of trim removal tools, specifically containing one for removing the plastic fasteners on the front bumper, Any i can buy off the shelf would be a bonus too, although links to on-line purchases would be good also Random search found the link below http://www.griotsgar... with hammer.do the Little hammer is quite cool Thanks

It would be nice if these controls were illuminated, had a call come through last night and was fumbling around on the controls trying to answer and ended up cutting them off, Was only the girlfriend though I'm sure i will get used to the controls soon enough, my last Saab was quite overkill on illumination but good at the same time.

Oh, assumed it was just the recent wet weather , ok then i will investigate that Thankyou

Hi I have noticed a few times when looking under the bonnet a small puddle of water sitting at the bottom of the front bumper Does anyone have this problem, are there drainage holes there, does it need a few more drilled Its an 04 plate Thankyou

Very helpfull Was expecting some RCA leads on the unit, is this because its non Bose. cheers

Hi Guys As above my passenger mirror does tilt but gets somewhat stuck part way down. Any ideas whether i can fix this, has the glass become misaligned or knocked. thanks for any help. Edit: Are the mirrors supposed to tilt automatically when in reverse, just wondered as mine don't.

Thanks Dave So no problem with the speaker ohm's, and as long as the HU has pre-outs then good to go. CAD seems the place to get the wiring harness and cage etc. Thanks

Hi Guys I am quite interested to know what other members have done to there Zed's in the way of audio changes. In particular whether its been a full install of a new HU, amps, speakers and wiring, or a partial install of maybe just the HU. is a partial install possible? ive read that everything would need to be replaced due to different ohm's of the speakers.maybe there's other factors. Ive read the threads on kit needed for adding an aftermarket head unit which is a great help, but any links to threads involving the installation with pics etc would be excellent. Before buying the Zed i read a few posts saying how the Bose wasn't all that, well after coming from a really really bad audio setup in my previous car it sounds very good to me. But i can see or rather hear that it lacks something, My plan would be to first change HU, the front components, and deaden the doors. Change the original sub maybe for something better. I have some 6.5 components i would like to use, would these fit the front doors? does someone have a diagram of the Bose setup please with speaker sizes etc Many thanks for any help

Thanks Ive heard of people doing TB3 or The Big Three when it comes to car Audio, i don't believe any audio upgrade has been done in the car, although it could of been taken out. Does the Zed have known grounding problems.

Hi all I have about four lengths of what looks like 8 AWG Stinger ground wire in the engine bay. I will take a pic and post it up, basically im trying to confirm whether its OEM or has been added after, so i can let insurance know. If it was intended for an ICE install, or a performance mod i would of expected bigger wire to have been used? Thanks

I would be interested if that worked too Thats a nice looking unit, with the bonus of AUX in for mp3 Would save alot of hassle if it was plug and play, although would the newer unit have better sq. I was thinking of putting a Pioneer DEH P80rs in there

Thanks Ill going to take a closer look over the weekend, the Nissan part mentioned looked like a typical siren, so this maybe the alarm? Having looked at the actual sensors, they got a few marks around the holes, so not a great job. Ill get some images up soon, and as mentioned before i need to either get underneath/ take bumper off the car. Ps Noticed your sig and the Audio setup, have you got a thread on here with the install/pics. I would like to upgrade at some point, and ive got some SPL dynamics 6.5 components to use Thanks