Ruddles

...but so worth it!

to the forum!

to the forum!

It's not that great I'm still learning CS4, so much involved! I'm sure there are some PS vets here though! Sure, send a pic and specify what you want. I'll fashion something up!

viewtopic.php?f=37&t=1781

Looks great!

Hope that's what you're after! p.s. Excuse the editing...it's late!

...payback will be swift!

Still saving the pennies for my system! Quite simply jack the car up, wheels off and get the tape measure out Best bet is to latch onto a mechanic friend (2 thumb friend if possible ) and get them to set it all up for you! Do be careful when jacking the car up as mine will no longer accommodate a trolley jack underneath!

She's in a proper colour now Ian!

We didn't do this with mine, but I'd say drop them all by 10mm before they're even on the car, once bedded in quite well you can go about changing them to what you want. They barely drop at all after the bedding in process so gives you plenty to play with! Just make sure the damping is same all round and that the rear extensions are connected fairly tightly, went 16 clicks on all for mine. You can twist the strut to lower/higher to your preference, mine will hopefully be finished after work this week along with discs and pads I have to fit

to the forum!

For Ian !

to the forum!!

They're great dude! Mine still need to be played with a bit, rear needs to be dropped some more and the front just needs springs wound. Front is pretty low : Hope these help!

Thanks alessandro! I'll give CS a PM!

In need of some decats, preferably Japspeed (unless anyone can give me a reason not to ). If anyone can point me in the right 'trader' direction that would be great. Thank you!

Thanks for the feedback, I'll leave them be!

Just wondering if anyone's had any experience with these? http://www.japspeed.co.uk/Nissan-350Z/N ... -19-1-258/

Looks great dude!

Hi bodyboarder, think we've spoken before regarding the BC's. I've the same spacer setup as you and about 20-25mm drop all round, the wheels just clear the arch without any rubbing, 30mm spacers would most likely rub if you went 25mm, get them rolled!

Sounds good Wasso, though I'm sure much better in life and not on a vid! Thanks kindly guys! Looking into this over the weekend and pretty much set on Japspeed decats ( I would assumed resonated). Do we have a trader on here who stocks them, or will I have to buy them direct from Japspeed themselves?