Gizmo-R

Try Advance Motorsport Engineering in Silverstone!

Your sub has 4 ohm impedance and I am assuming it is a Single voice coil judging by the connectors The amp you have is a 2 channel amp so what you want to do is bridge the channels into one. In other words connect one wire to the negative of one channel and positve of the other. This should be obvious which one when you look at the engraved labelling on the amp. The way you can only have it configured is 1 x 300W RMS because of the impedance of your sub (@ 4ohm) Basically you aren't even swaeting your amp! You would need another one of those boxes and wire it in parallel to get a nominal impedance of 2ohms to get more power out of the amp (600W RMS) If you want to go crazy then to get the most out of the amp with the subs you have you would need 4 of them to gain a nominal impedance of 1ohm! With that kind of setup you will be hated by your neighbourhood within a 3 mile raduis!

BUMP again, Open to offeres

Nice sounding white Zed heading down south on the M1. Couldn't pick out what exhaust you had but it was very loud!

BUMP! Still available!

I had the same problem with mine Guide is here: viewtopic.php?f=35&t=141 You have to take door card off and there is a hole you have to poke ( i think they say switch but when I looked at it it was more like pushing a mechanical part in)

Now Sold. Mods can lock now. Ta

Another BUMP!

Another Bump! This is required if you want to change to aftermarket HU. If you buy from sextons total inc delivery is around £40!

Sold now. Mods to lock

Sold now. Mods to lock Ta

BUMP!!! Item it delivered free just in case it is not clear in UK mainland!

BUMP!!!

BUMP!!!

Now Sold. Mods can now lock this thanks

Provisionally Sold pending payment

Oh FYI If you require this to interface with a different brand of stereo then all you would need to purchase is the adapter lead which is around £5-6

Provisionally Sold pending payment

This item is now sold. Mods can lock this now Ta

Bluetooth adapter to integrate into the Bose system. £50 Delivered Free

Sold to the above. Mods feel free to lock this one! Ta

I would put this one my new car except it has the 350z etched on it! It is a great bit of kit!

Ahhh Pre-facelift buddy! Will amend TA

This is the sorround bit that fills in the gaps of a Double DIN install To give you an example here it is installed in my ZED: £10 Delivered Free

InCarTec Universal Steering Wheel Control Loom with Car Specific connectors to ISO. This loom enables you to use an aftermarket head unit with your standard loom. Comes with JVC interface lead (these are around £6 if you need a different make of HU) Originally bought from sextons direct £25 Delivered free