350 Russ Posted September 6, 2014 Posted September 6, 2014 (edited) As above, my nut has rounded so I cannot get the rubber hose off that feeds my slave cylinder to change to the braided one. Its shown here in this diagram. Edited September 6, 2014 by 350 Russ Quote
ZMANALEX Posted September 6, 2014 Posted September 6, 2014 If it is the end that I think it is then mole grips or vice grips should do the trick, however you may have to chop off the male rounded end and fit a new one using a flaring tool. Alex. Quote
350 Russ Posted September 6, 2014 Author Posted September 6, 2014 If it is the end that I think it is then mole grips or vice grips should do the trick, however you may have to chop off the male rounded end and fit a new one using a flaring tool. Alex. It's the end nearest the slave cylinder on the male fitting to the hose. I've had grips in there but it wouldn't budge and not much room in there for anything else Quote
Shades Rs Posted September 7, 2014 Posted September 7, 2014 I will have a look later on today to see if I can help you out? I'm sure I can. Cheers Sent from my iPhone using Tapatalk 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.