Wire between passenger footwell and driver's side

[Shinjuku]

I want to get a wire (very thin - 10amps) from the driver's footwell to the passenger footwell. Had a little look and there is not massively obvious way through between the two footwells. Can anyone suggest what can be done. All I need really is to be able to see a bit of light from the driver's footwell if I poke my head into the passenger footwell - then I can poke the wire through.

 

Suggestions on how to do it appreciated.

 

Thanks

Shinjuku

[DannyBoy]

If you're after a thorough and tidy way to do it, i'd remove the gear surround, and knee pad trim (may need to remove centre console as well) and run the wire from footwell to footwell via the gearstick area where i remember there being a fair bit of space between the transmission tunnel and the trim. Sounds a bit scary but it should be pretty straightforward

 

Just out of interest, what are you doing with the wire?

 

DB

[DoogyRev]

Depends where you want to enter and exit?

 

Its easy to thread a bit of wire between the two with the centre dash off

[Zugara]

Remove the head unit, that way it will be a lot easier to run the cable over the tunnel.....

You will never know what you will be poking if you go in blind.

[Shinjuku]

@db

Its a wire for a 12v extension. I have a gps speed camera warning system and it needs a power supply.

 

All those panels sounds like a bit of a faff. Is there some guides that can step by step me on how its done?

 

@ doogyrev

What do you mean when you say the centre dash and how do you get it off

 

@zugara

Thats what I call a good party!

[DoogyRev]

Have a look here http://www.350z-uk.com/forum/viewtopic.php?f=35&t=15617

 

The whole centre section can be removed, from the triple gauges to the gear surround, thus allowing access behind to easily locate your wire

[spursmaddave]

If you just remove the gear surround you should be able to push it up between the trim and the carpet I reckon

[Shinjuku]

Thanks all

Shinjuku