D1 GT THROTTLE CONTROLLER

[wilo]

okay just been for a blast and noticed the controller starts at 11% and only goes up to 97% .

 

i had a few issues when fitting it and might of unwittingly set it up this way due to the LED screen not functioning properly at the time .

 

so how do i reset the unit ?

do I just disconnect the battery or does it have an internal battery within the unit ?

 

just need it resetting to factory settings and start again

[wilo]

any one ?

[buster]

unplug and leave for 10mins or so then plug back in and reprogram

[wilo]

unplug and leave for 10mins or so then plug back in and reprogram

thanks buster

[wilo]

disconnected battery for 30 mins and when i re attached it the throttle controller had retained its settings ? do i have to unplug the actual unit from the obd port and throttle plug

[Adam B]

http://www.350z-uk.com/topic/105649-installation-guide-350z-de-d1-spec-gt-throttle-controller/

 

I would say just go through the setup procedure again, it should recalibrate as if new.

Or is this sorted now?

[wilo]

http://www.350z-uk.com/topic/105649-installation-guide-350z-de-d1-spec-gt-throttle-controller/

 

I would say just go through the setup procedure again, it should recalibrate as if new.

Or is this sorted now?

no its still same mate just havnt had time to sort it yet with getting the car sorted from the crash

[Adam B]

Crash?

Hope its repairable and your alright

[wilo]

Crash?

Hope its repairable and your alright

yea car and me are fine cheers pal .

hit a curb stone at 80 and buckled nsf alloy , riped tyre , punctured braided nsf brake hose , bust slave cylinder hose and nackered slave , slight curbing on nsr alloy .......alot of heart ache for my stupidity but lesson learnt

[wilo]

last pic rear alloy

 

Sent from my SM-G935F using Tapatalk