chrisday1990 Posted May 31, 2015 Share Posted May 31, 2015 (edited) Hey fellow Zers Over speed bumps at low speeds I have a clunk clunk from front LHS, a few garages seem unsure so I was wondering is there any definitive way to find the knock because it's expensive to get it worong, I have seen MOT centres with the rumble jacks maybe these? And if I leave it to get worse could this make it easier for a garage to spot? Edited May 31, 2015 by chrisday1990 Quote Link to comment Share on other sites More sharing options...
Angrybiker Posted May 31, 2015 Share Posted May 31, 2015 It's hard to say without hearing it but I had a clunking/rattling noise recently when going over speed bumps. Replaced front shocks which cured it Sent from my iPhone using Tapatalk 1 Quote Link to comment Share on other sites More sharing options...
ZMANALEX Posted May 31, 2015 Share Posted May 31, 2015 Chris, More than likely it will be the compression rod ball joint (banana arm) so this would be a very good place to start, however difficult to find play with a pry bar. Plenty in stock if required, just drop me a PM if I can help further. Alex. 1 Quote Link to comment Share on other sites More sharing options...
redzed8 Posted May 31, 2015 Share Posted May 31, 2015 (edited) I had the same problem but drivers side. This is what i found when i took the dust cover off my old banana arm ball joint . Sounded just like this when it was on the car too. Edited May 31, 2015 by redzed8 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.