lrenno Posted June 30, 2008 Posted June 30, 2008 Hi guys will be fitting my JWT pop charger and ESR intake pipe tomorrow. just wondering is there anything special i need to do or is it literally jus disconnect and fit the new one? Do the sensors just plug straight back in new pipe and pop charger? cheers Quote
bigphil Posted June 30, 2008 Posted June 30, 2008 Hi guys will be fitting my JWT pop charger and ESR intake pipe tomorrow.just wondering is there anything special i need to do or is it literally jus disconnect and fit the new one? Do the sensors just plug straight back in new pipe and pop charger? cheers Just follow the instruction sheet which is with the heatshield and you should have no problems, if you get stuck just phone. Quote
martinmac Posted June 30, 2008 Posted June 30, 2008 Theres a video in the guides section bud but basically its pretty straightforward. The most awkward bit is getting the screws into the heat shield. I had one of the 90 deg drives and that made it easy. Just put the sensors back in and I was expectiong alsorts but just started it up and drove it. Quote
Ian Posted June 30, 2008 Posted June 30, 2008 Theres a video in the guides section bud but basically its pretty straightforward. The most awkward bit is getting the screws into the heat shield. I had one of the 90 deg drives and that made it easy.Just put the sensors back in and I was expectiong alsorts but just started it up and drove it. +1 the screws for the heat shield took me longer than the rest of the job Quote
martinmac Posted June 30, 2008 Posted June 30, 2008 Definatley worth getting the right tool for this, it could really drive you mad Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.