chalks

Ok, thanks for your input. I'll come your way for parts in future!

Thanks for the advice! It's a TTV billet flywheel, v nice quality, 6.4kg: I put an OE slave cylinder in and a Competition Clutch kit from Torqen, which I hadn't heard of but was recommended to me! I've had solid flywheels (not lightweight exactly) but not had the resonance I'm getting with this setup. Fine down country lanes but driving in traffic may become annoying... Thanks again for your help

Hi, thanks for your input- it's only been in for 150 miles but yes, I'm now automatically trying to keep it over 2000rpm. So you don't think it's something in the transmission that is highlighted by the solid flywheel?

Hi all, I know there is already a lot of coverage on clutch & release bearing noise, but I think mine's different! I've recently fitted a lightweight flywheel and new clutch & spigot bush, and now have v noticeable noise/chatter when on throttle, below 2k rpm. It goes away at higher revs... It's not the same chatter as I had with the DMF at idle.... there is no noise at idle. I've seen in a couple of posts people have said it could be the gearbox idler gear / input shaft bearing- is that right? Also does anyone stock the parts or do they have part numbers? Thanks!

Hi, is it worth doing the software update only? Any nice new features??

Hi, sorry been away for a few days.... No I never figured it out!! If I leave the toggle switch on, the LED flashes green after a few mins, and then some time later it flashes red and starts beeping at me.... I've no way to test whether it's a jammer and I don't want to take my dash apart to find out...

Ah ok, thanks for the info! Sounds like a bit too much trouble then... It's a shame as if they'd sell the updates for even £40 or so I'm sure a lot more people would go for it!

Hi All, I saw that Nissan have the 2014/2015 update available to purchase now.... http://www.navigation.com/370Z-2011/Connect-Premium--X9--Europe-2014-2015/nissan-eu/product/T1000-22697/en_GB/EUR/ Has anybody taken the plunge and bought a copy, or has anyone seen this available cheaper anywhere else (i.e. eBay...)? Would anybody be interested in splitting the cost of the pack (179 EUR) and we can then have them circulating as these discs were?? Chalks

Had a bit of a hiccup updating my friend's Z yesterday... Word of caution, don't get distracted by the F1 and leave the car on but not running for 3 hours or this might happen: All sorted now though! I did mine without the engine running no probs, but I guess it's best to at least alternate engine on/off between discs!

Hi, alroma has baggsied them so I'll send them as soon as I can.

Hi, I have bodeboo's set. I've done my car and the discs worked perfectly, but I have to update a friend's before I can post out (hopefully this weekend). If anybody want me to send the discs to them once I'm done, pm me!

Hi, Picked up some Superforma spacers from Cougar Store on Friday and fitted them at the weekend. Thanks Mitz! I went for 25mm all round and I'm really pleased with them! The quality of the parts and machining looks excellent so I'd recommend them if you're looking for an alternative to Eibach etc. I think it improves the stance no end, and I don't have any wheel shake etc after fitting them. Even so, I'll be getting the alignment checked asap. Here's the finished product:

Nismo looks so good, well worth sacrificing the back seats for I think! Sent from my XT1032 using Tapatalk

Fairly inconsequential article but worth a quick lunchtime read: http://www.pistonhea...others#topicTop

Thanks both I'll search for bld99 and RTFM! Sent from my XT1032 using Tapatalk