fellsteruk Posted July 10, 2013 Posted July 10, 2013 Ok, so part way through installing my reverse camera and I was going to take it to the reverse break light for power but I would like it to have constant power for use when driving or not in reverse any ideas for a possible power source. My 2nd question is about the reverse line, the alpine head unit says: "By shifting to reverse ®, the rear pictures are output. This function is effective when the reverse wire is properly connected" Does anyone know how I can wire the head unit to this ? Thanks Quote
fellsteruk Posted July 10, 2013 Author Posted July 10, 2013 (edited) May have answered my 2nd question myself, just found this.... Reverse Lead (Orange/White) Use only when a back-up camera is connected. Connect to the plus side of the car’s reverse lamp. This lamp illuminates when the transmission is shifted into reverse ®. With this lead properly wired, the video picture automatically switches to the back-up camera whenever the car is put into reverse ®. Does this mean I have to run a wire from the reverse light "the boot" all the way to the head unit? Edited July 10, 2013 by fellsteruk Quote
cs2000 Posted July 10, 2013 Posted July 10, 2013 Yep. In the boot the revsers camera wire is bundled up with a load of others, but its a page green with silver stripe. Obviously you would suspect this is also somewhere else in the car, but just route from there Quote
Briggsybriggs1 Posted July 10, 2013 Posted July 10, 2013 There is a guide on here i used to fit my cam last month if this helps at all. ............. KENWOOD DDX-4028BT / REAR CAM INSTALL – SUPERGUIDE Started by AFTERSHOX, Feb 22 2012 20:18 Quote
fellsteruk Posted July 10, 2013 Author Posted July 10, 2013 Thanks guys.. Yeah that guide has been helpful.... I think I may have to rethink things..... Just checked and I don't have the "remote in/out" cable connected to the head unit, this is needed to connect the reverse power feed had a look on ebay and struggling to find the connector. Going to see if I can buy one direct from alpine or try hack it Quote
techinstaller Posted July 10, 2013 Posted July 10, 2013 The remote cable in out you refer to is surely the standard RCA type connector ? we also use those which carry a 12V feed inside with just a tail of a few inches either end which saves an unsightly extra single wire and just makes for a bit less work Quote
fellsteruk Posted July 10, 2013 Author Posted July 10, 2013 The remote cable in out you refer to is surely the standard RCA type connector ? we also use those which carry a 12V feed inside with just a tail of a few inches either end which saves an unsightly extra single wire and just makes for a bit less work It's a 6pin connector similar to a a pci express power connector from a PC. Managed to find one in maplin which I think and hope will fit, gonna take a look tomorrow Quote
madmikester Posted July 11, 2013 Posted July 11, 2013 (edited) If you want constant power you can use the power from the Bose amp think it's the yellow n red cable positive n black negative well that's what I did as I can have it on will driving too looks rely good when u put your foot down Sent from my HTC One X+ using Tapatalk 2 Edited July 11, 2013 by madmikester Quote
fellsteruk Posted July 11, 2013 Author Posted July 11, 2013 If you want constant power you can use the power from the Bose amp think it's the yellow n red cable positive n black negative well that's what I did as I can have it on will driving too looks rely good when u put your foot down Sent from my HTC One X+ using Tapatalk 2 Thanks, did just that and its working a treat. the other half spent the whole trip home from her mums watching the HU screen as i drove away in amazement Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.