Yaw sensor bypass switch

[Initial_j]

Looking to put a switch into the yaw sensor to fully disable traction control on a aftermarket switch 

 

found a few guides but for older 350z so the wiring colours are different 

 

looking at attached picture, does anyone know which wires to use

 

mine is a late 2006 model, facelift interior/lights etc 

 

picture:

[andybp]

have you tried unplugging it to see if it actually disables the traction control ? if so the old ones had a 12 volt supply, use a volt meter to find the 12 volt supply cut the wire and put the switch in there well theoretically anyway

[karlh]

The white wire with the red stripe is ground (earth in the Queen's english).  Interrupting this lead will take the yaw rate sensor out of the loop.  I recommend using this wire instead of the 12v wire to avoid any possible electrical glitches.

 

[Initial_j]

Thanks guys

 

andy- unplugging it compeletly would work but would have the dash lights on permanently. Rather have it switchable 

[bc1987]

On ‎17‎/‎06‎/‎2018 at 09:26, Initial_j said:

Thanks guys

 

andy- unplugging it compeletly would work but would have the dash lights on permanently. Rather have it switchable 

have you installed this successfully?

[danielb186]

Also interested if this worked.

[bc1987]

So I have done this now. Switch work but waiting to see how long before the lights go back out ...

[zenozeno]

any update its been 3 years... looking into doing this and the thread went cold lmao

[bc1987]

Yes I have done it and it works great.