-
Posts
41 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Gallery
Store
Posts posted by checkle91
-
-
Had my Torqen HFC fitted on my 350z DE since beginning of year, flew through MOT emissions today! Another thumbs up on these from me.
-
Ahh so he did
Cheers for that bud
-
Been looking for a spoiler for my roadster and the best one I have seen is the one discussed here. Can anyone tell me if it is a particular brand or where to get this from? The OP has not been on here for a few years so messaging them is out of the question.
-
2 minutes ago, HEADPHONES said:
Really nice finish on those.
I'd even go as far to say
"Wheely wheely" good job
Wheely nice of you to say so
-
On 29/03/2020 at 11:04, zippypooz said:
Hi all, i've wanted something on my fuel cap for a while now and decided to design a printed clear sticker...I've 'set up' a brand called No Religion Mods which is dedicated to the 350z for now but i'll be adding other models in the future. So this is one of the designs...
I'm selling these for £12 including postage via paypal. Colours are as follows:
Red with black text Red with red text
Black with black text Black with red text
Lime with black text Lime with lime text
Orange with black text Orange with orange text
Cerise with black text Cerise with cerise text
Yellow with black text Yellow with yellow text
To apply: Spray some slightly soapy water on to the fuel cap and lay the sticker
in place, then squeegee out the excess water and you're done!
Metallic paint will show through the sticker making it look metallic too...which is nice!
how do you purchase? would like a red one with black text please
-
On 05/08/2020 at 21:23, swillo said:
Very nice! I had mine done there recently, very impressed with them.
- 1
-
Thanks for your feedback
I think I will leave it alone and save the cash then.
- 1
-
Looking for some knowledge and opinions please.
My 350z DE currently has the following exhaust setup...
HFC, cobra sport y pipe, fujitsubo legalis r axle back.
Can anyone tell me if I stand to gain anything by fitting the fujitsubo y pipe which has a much shorter exhaust gas collector compared to the cobra pipe? Does the design of the cobra, where the exhaust gases merge much sooner have any negative impact on performance?
-
On 01/05/2020 at 20:33, Oversteer said:
pm'd
Has this sold?
-
I have now sorted this. I Removed all brake pads today and shaved some material from the edges of the pads where they run on the sliders. Although I did this when I first fitted the pads, I don't think I took enough off as the fronts still felt a tad tight.
A full bleed all round again just to be sure the system is air free and the brakes are on point now. The car stops hard, fast and perfectly straight without locking any wheels !
-
Hi all,
Replaced NSF Brembo caliper two weeks ago due to snapped caliper bolt in old unit trying to remove.
I fitted new grooved black diamond discs and pads front and rear at the same time as fitting the replacement caliper.
Bled whole system in correct sequence twice and brakes are now strong and pedal feel normal two weeks on. But here is the issue...
... The car brakes and stops perfectly straight a few times in succession when the brakes are cold but after some hard braking when the discs are hot, light braking is OK still but when I stamp on the pedal, the car wants to pull to the right and the steering wheel is off to the left to keep the car in a straight line. I can also lock the OSF wheel when I brake very hard and instead of the ABS kicking in the one tyre just squeels.
I am at a loss here as there is no air in the system and the issue only shows when brakes are hot?
The coating on all the new discs has cleared evenly so I can see all 4 calipers are working against the discs.
-
Both left and right in good condition.
Thanks
-
**No longer needed as bought a set of Torqen HFC**
Looking for a pair of original Cats that will pass MOT emissions test.
Mine have corroded at flanges and missing heat shields so they need to be in useable condition.
Thanks
-
Thanks for the welcome guys .
-
Just a quick introduction from me to all forum members.
I'm Tom and I bought a 350z Coupe in 2014 and sadly had to sell a year later due to having a little boy and needing something more sensible.
However, he is now nearly 5 and as I have my SEAT Leon ST and I have some spare cash, I have gone and bought an 2005 350z Roadster! Absolutely loving my second Z and have booked on the club stand for this years Japfest at Silverstone. Look forward to seeing you and your cars there!
-
1. andy James PAID
2. Sebastian PAID - Track 12.40
3. Stephanie
4. Andy_Muxlow PAID
5. SHEZZA PAID
6. Silverthorn PAID
7. Cs2000 PAID - Track 14:40
8. nissmoandy PAID
9. Paul K - PAID
10. V1H PAID
11. Matthew Thain PAID
12. Jamie Thain PAID13. whitevanman. PAID
14. Mark350Z. PAID - Track 14.4015. luigi350z PAID
16. Sarah PAID
17. zzincubus (Len Meakin) PAID
18. Flashback - PAID
19. FruitPolo PAID
20. BUSTER PAID
21. Trott + 1 PAID22. George (tarmacsportz) -PAID
23. Valy - PAID
25. MattRwebB - will pay end of month
26. Terry - Paid
27. Jamie - paid
28. checkle91 - PAID
- 1
Roadster Roof Fault
in 350Z General
Posted
Hi all!
So have owned my 350z Roadster for just over a year now and has been problem free until today.
The car has been sat outside come rain, shine or snow for about 3 months due to needing use of the garage.
Found battery was dead yesterday so took it off and gave it a full charge overnight, battery back on today and fired up the car.
Roof fully opened with no issues but noticed the roof dash light was still lit solid after opening roof. Went to close the roof and it all closes up until the point when the glass should come down onto the deck lid but it stops at this point with the glass still upright. The deck lid folds down but the glass section of the roof doesn't come down.
Any suggestions would be a great help.